[U-Boot] [PATCH 2/5] Enable booting of mx28 without battery

[Marek Vasut]

On Wednesday, January 21, 2015 at 12:55:15 PM, Graeme Russ wrote:
> Section 4.1.2 of Freescale Application Note AN4199 describes the
> configuration required to operate the mx28 from a 5V source without a
> battery. This patch implements the changes to the Freescale bootlets
> which allow this configuration to properly boot the mx28 processor
> 
> Signed-off-by: Graeme Russ <gruss at tss-engineering.com>

I have to admit I don't really like this boatload of new ifdeffery. Isn't it
possible to detect if the battery is or isn't connected at runtime ?

Best regards,
Marek Vasut