[U-Boot] [PATCH 11/11] imx: mx6ul_14x14_evk add basic board support

[Marek Vasut]

On Thursday, July 02, 2015 at 01:03:08 PM, Peng Fan wrote:
> Add USDHC, I2C, UART, 74LV, USB, QSPI support.
> 
> Boot Log:
> U-Boot 2015.07-rc2-00085-gb5dc629 (Jul 02 2015 - 18:47:15 +0800)
> 
> CPU:   Freescale i.MX6UL rev1.0 792 MHz (running at 396 MHz)
> Reset cause: POR
> Board: MX6UL 14x14 EVK
> I2C:   ready
> DRAM:  512 MiB
> MMC:   FSL_SDHC: 0, FSL_SDHC: 1
> *** Warning - bad CRC, using default environment
> 
> In:    serial
> Out:   serial
> Err:   serial
> Hit any key to stop autoboot:  0
> 
> Signed-off-by: Ye.Li <B37916 at freescale.com>
> Signed-off-by: Peng Fan <Peng.Fan at freescale.com>
> ---
>  arch/arm/Kconfig                                  |   7 +
>  board/freescale/mx6ul_14x14_evk/Kconfig           |  15 +
>  board/freescale/mx6ul_14x14_evk/MAINTAINERS       |   6 +
>  board/freescale/mx6ul_14x14_evk/Makefile          |   6 +
>  board/freescale/mx6ul_14x14_evk/imximage.cfg      |  99 +++++

I think you should consider switching this board to SPL and get rid
of this imximage way of configuring DDR DRAM from the getgo.

>  board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c | 502
> ++++++++++++++++++++++ configs/mx6ul_14x14_evk_defconfig                 |
>   3 +
>  include/configs/mx6ul_14x14_evk.h                 | 221 ++++++++++
>  8 files changed, 859 insertions(+)
>  create mode 100644 board/freescale/mx6ul_14x14_evk/Kconfig
>  create mode 100644 board/freescale/mx6ul_14x14_evk/MAINTAINERS
>  create mode 100644 board/freescale/mx6ul_14x14_evk/Makefile
>  create mode 100644 board/freescale/mx6ul_14x14_evk/imximage.cfg
>  create mode 100644 board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
>  create mode 100644 configs/mx6ul_14x14_evk_defconfig
>  create mode 100644 include/configs/mx6ul_14x14_evk.h

[...]

Best regards,
Marek Vasut