[U-Boot] [PATCH] thermal:imx_thermal: enter busywait cooling loop when over max CPU temp

[Stefano Babic]

Hi Tim,

On 09/07/2015 00:46, Tim Harvey wrote:
> On Tue, Jun 9, 2015 at 6:40 AM, Tim Harvey <tharvey at gateworks.com> wrote:
>> Remove the check for temperature being within the min/max range and enter the
>> busywait cooling loop whenever the CPU temperature is over the critical temp.
>> This fixes the issue where if a board was booted at a temp greater than
>> the CPU temperature max, it would skip the loop and never indicate or try
>> to address the overtemp issue.
>>
>> Cc: Ye Li <b37916 at freescale.com>
>> Cc: Jason Liu <r64343 at freescale.com>
>> Signed-off-by: Tim Harvey <tharvey at gateworks.com>
>> ---
>>  drivers/thermal/imx_thermal.c | 16 ++++++----------
>>  1 file changed, 6 insertions(+), 10 deletions(-)
>>
>> diff --git a/drivers/thermal/imx_thermal.c b/drivers/thermal/imx_thermal.c
>> index 0d893c9..42ca8d0 100644
>> --- a/drivers/thermal/imx_thermal.c
>> +++ b/drivers/thermal/imx_thermal.c
>> @@ -130,16 +130,12 @@ int imx_thermal_get_temp(struct udevice *dev, int *temp)
>>         int cpu_tmp = 0;
>>
>>         cpu_tmp = read_cpu_temperature(dev);
>> -       while (cpu_tmp > priv->minc && cpu_tmp < priv->maxc) {
>> -               if (cpu_tmp >= priv->critical) {
>> -                       printf("CPU Temperature (%dC) too close to max (%dC)",
>> -                              cpu_tmp, priv->maxc);
>> -                       puts(" waiting...\n");
>> -                       udelay(5000000);
>> -                       cpu_tmp = read_cpu_temperature(dev);
>> -               } else {
>> -                       break;
>> -               }
>> +       while (cpu_tmp >= priv->critical) {
>> +               printf("CPU Temperature (%dC) too close to max (%dC)",
>> +                      cpu_tmp, priv->maxc);
>> +               puts(" waiting...\n");
>> +               udelay(5000000);
>> +               cpu_tmp = read_cpu_temperature(dev);
>>         }
>>
>>         *temp = cpu_tmp;
>> --
>> 1.9.1
>>
> 
> Stefano,
> 
> Any feedback on this?

Sure !

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================