[U-Boot] [PATCHv4 0/3] drivers/ddr/altera: Add the DDR controller driver for SoCFPGA

[Marek Vasut]

On Wednesday, July 22, 2015 at 12:46:15 AM, Dinh Nguyen wrote:
> On 07/20/2015 02:40 PM, Marek Vasut wrote:
> > On Monday, July 20, 2015 at 09:31:39 PM, Dinh Nguyen wrote:
> > [...]
> > 
> >>>>> Hi,
> >>>>> 
> >>>>> yeah, I have some insane amount of cleanup patches and fixes already.
> >>>>> I will post them once I'm done. What I am sorely missing is the
> >>>>> UniPHY register interface documentation, it looks like that is not
> >>>>> public, so I don't exactly know if what sequencer.c does is really
> >>>>> correct. Sometimes I have serious doubts about that too . Can you
> >>>>> give me the documentation please ?
> >>>> 
> >>>> Have you seen this link[1]?
> >>> 
> >>> Yes, but that is by far not all of the registers used in the
> >>> sequencer.c, is it ?
> >> 
> >> Looks like it's in the entire emi.pdf file[1]. Please look at volume 3,
> >> or page 531 of 895. The section for the UniPHY.
> > 
> > I extracted all the possible addresses used in the sequencer while
> > cleaning it up, they're below. I cannot find these in any documentation.
> > I checked the EMI RM, sure, but there seems to be many more registers
> > all around the place than what are described in the EMI RM. Any ideas
> > please ? Maybe this is not even the UniPHY anymore ?

Hi!

> I'll try to get those questions answered for you shortly.

Thanks!

> BTW, I tested out our your branch, but I think I'm missing a step as
> where to put the SPL DTB?
> 
> 
> U-Boot SPL 2015.07-rc3-00100-ga2e2da6 (Jul 21 2015 - 17:15:54)
> drivers/ddr/altera/sequencer.c: Preparing to start memory calibration
> drivers/ddr/altera/sequencer.c: CALIBRATION PASSED
> drivers/ddr/altera/sequencer.c: Calibration complete
> Missing DTB
> ### ERROR ### Please RESET the board ###

Do:

make u-boot-with-spl-dtb.sfp

This will produce u-boot-with-spl-dtb.sfp, which you write directly to that
0xa2 socfpga boot partition. It includes U-Boot SPL, DTB and U-Boot. You will
also need to define CONFIG_SPL_MMC_SUPPORT in include/configs/socfpga_common.h
as I didn't solve how to configure this on per-board basis, do this before
building the U-Boot of course.

Best regards,
Marek Vasut