[U-Boot] [PATCH] ARM: DRA7: Change configuration to prevent DDR reset control from EMIF
Nishanth Menon
nm at ti.com
Tue Jun 16 15:29:01 CEST 2015
DRA7/AM57xx devices can be operated in many different configurations.
When the SoC is supposed to support a configuration where low power mode
state may involve the SoC completely powered off and DDR is in self
refresh, SoC EMIF controller should not be the master of the reset
signal and an external entity might be in control of things.
The default configuration of Linux on TI evms involve not powering off
the voltage rails (due to various reasons including reliability concerns)
and must not allow DDR reset to be controlled by EMIF. On platforms
where external entity might control the reset signal, this configuration
will be a "dont care".
Fixes: 536d87470869 ("ARM: DRA7: Update DDR IO registers")
Tested-by: Keerthy <j-keerthy at ti.com>
Acked-by: Brad Griffis <bgriffis at ti.com>
Signed-off-by: Nishanth Menon <nm at ti.com>
---
Based on master b48b69ba10fd Merge git://git.denx.de/u-boot-marvell
arch/arm/cpu/armv7/omap5/hw_data.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/arch/arm/cpu/armv7/omap5/hw_data.c b/arch/arm/cpu/armv7/omap5/hw_data.c
index f1a59a3ca918..3a723cace71a 100644
--- a/arch/arm/cpu/armv7/omap5/hw_data.c
+++ b/arch/arm/cpu/armv7/omap5/hw_data.c
@@ -602,8 +602,8 @@ const struct ctrl_ioregs ioregs_dra7xx_es1 = {
.ctrl_ddrio_0 = 0x00094A40,
.ctrl_ddrio_1 = 0x04A52000,
.ctrl_ddrio_2 = 0x84210000,
- .ctrl_emif_sdram_config_ext = 0x0001C127,
- .ctrl_emif_sdram_config_ext_final = 0x0001C127,
+ .ctrl_emif_sdram_config_ext = 0x0001C1A7,
+ .ctrl_emif_sdram_config_ext_final = 0x0001C1A7,
.ctrl_ddr_ctrl_ext_0 = 0xA2000000,
};
@@ -614,8 +614,8 @@ const struct ctrl_ioregs ioregs_dra72x_es1 = {
.ctrl_ddrio_0 = 0x00094A40,
.ctrl_ddrio_1 = 0x04A52000,
.ctrl_ddrio_2 = 0x84210000,
- .ctrl_emif_sdram_config_ext = 0x0001C127,
- .ctrl_emif_sdram_config_ext_final = 0x0001C127,
+ .ctrl_emif_sdram_config_ext = 0x0001C1A7,
+ .ctrl_emif_sdram_config_ext_final = 0x0001C1A7,
.ctrl_ddr_ctrl_ext_0 = 0xA2000000,
};
--
1.7.9.5
More information about the U-Boot
mailing list