[U-Boot] [PATCH V3 6/6] imx: mx6qpsabreauto: Add MX6QP SABREAUTO CPU3 board support

[Fabio Estevam]

On Mon, Jun 29, 2015 at 11:58 AM, Peng Fan <Peng.Fan at freescale.com> wrote:
> 1. Add DDR script for mx6qpsabreauto board.
> 2. On CPU3 board, enet RGMII tx clock is from internal PLL. Set the GPR5[9]
>    and init the enet pll output to 125Mhz.
> 3. On CPU3 board, SW1ABC=VDDSOC_IN, SW2=VDDARM_IN.
>
> Build target: mx6qpsabreauto_config
>
> Boot Log:
> U-Boot 2015.07-rc2-00071-gfd985ff (Jun 29 2015 - 22:10:55 +0800)
>
> CPU:   Freescale i.MX6QP rev1.0 996 MHz (running at 792 MHz)
> CPU:   Automotive temperature grade (-40C to 125C) at 34C
> Reset cause: POR
> Board: MX6Q-Sabreauto revA
> I2C:   ready
> DRAM:  2 GiB
> PMIC:  PFUZE100 ID=0x10
> Flash: 32 MiB
> NAND:  0 MiB
> MMC:   FSL_SDHC: 0
> *** Warning - bad CRC, using default environment
>
> No panel detected: default to HDMI
> Display: HDMI (1024x768)
> In:    serial
> Out:   serial
> Err:   serial
> Net:   FEC [PRIME]
> Hit any key to stop autoboot:  0
>
> Note:
> In this patch, we still add a new config mx6qpsabreauto_config,
> since SPL is not supported now, and IMX_CONFIG is needed at
> build time, so add this config. Future, when SPL is converted,
> this config can be removed.
>
> Signed-off-by: Robin Gong <b38343 at freescale.com>
> Signed-off-by: Ye.Li <B37916 at freescale.com>
> Signed-off-by: Peng Fan <Peng.Fan at freescale.com>

Reviewed-by: Fabio Estevam <fabio.estevam at freescale.com>