[U-Boot] [PATCH V2 2/2] ARM: tegra: import latest Jetson TK1 pinmux

[Tom Warren]

I've been side-tracked with other work. Let me take another look, if it's all gravy I'll apply them to u-boot-tegra/next.

> -----Original Message-----
> From: Stephen Warren [mailto:swarren at wwwdotorg.org]
> Sent: Tuesday, March 03, 2015 1:19 PM
> To: Tom Warren
> Cc: u-boot at lists.denx.de; Simon Glass; Stephen Warren
> Subject: Re: [U-Boot] [PATCH V2 2/2] ARM: tegra: import latest Jetson TK1
> pinmux
> 
> On 02/18/2015 01:27 PM, Stephen Warren wrote:
> > From: Stephen Warren <swarren at nvidia.com>
> >
> > Syseng has revamped the Jetson TK1 pinmux spreadsheet, basing the
> > content completely on correct configuration for the board/schematic,
> > rather than the previous version which was based on the bare minimum
> > changes relative to another reference board.
> >
> > The new spreadsheet sets TRISTATE for any input-only pins. This only
> > works correctly if the global CLAMP bit is not set, so the Jetson TK1
> > board code has been adjusted accordingly. Apparently syseng have
> > changed their mind since the previous advice that this needed to be
> > set:-/
> >
> > This content comes from Jetson_TK1_customer_pinmux.xlsm (v09)
> > downloaded from https://developer.nvidia.com/hardware-design-and-
> development.
> 
> Tom, do these two patches look OK?
-----------------------------------------------------------------------------------
This email message is for the sole use of the intended recipient(s) and may contain
confidential information.  Any unauthorized review, use, disclosure or distribution
is prohibited.  If you are not the intended recipient, please contact the sender by
reply email and destroy all copies of the original message.
-----------------------------------------------------------------------------------