[U-Boot] Ask for help: Compulab CM-510 U-boot version: Load Kernel from SD-Card

[Gabriel Dobato]

Hi Dmitry,

Finally, I got the SD Card as a bootable kernel space. However I had to 
set the registers as below:

 >>>> #define CM_A510_MPP0_7                        0x00000033 (does not 
matter)
 >>>> #define CM_A510_MPP8_15                       0x00445050 (does not 
matter)
 >>>> #define CM_A510_MPP16_23                      0x33333333 <---- 
(SDIO0 and SDIO1)


Regards,

Gabriel



On 04/03/15 09:50, Dmitry Lifshitz wrote:
> Hi Gabriel,
>
> On 03/04/2015 10:18 AM, Gabriel Dobato wrote:
>> HI Dmitry,
>>
>> Thank you very much for your answer!
>>
>> I have tried it, but I get the same:
>>
>> CM-A510>> mmc init
>> CM-A510>> mmcinfo 0
>> Device: MV_SDHCI
>> Manufacturer ID: 0
>> OEM: 0
>> Name: Tran Speed: 0
>> Rd Block Len: 0
>> MMC version 0.0
>> High Capacity: No
>> Capacity: 0
>> Bus Width: 0-bit
>>
>> In reference to peripherals, only is available USB and Ethernet 0 by
>> default. I am searching in the sources just in case there is something
>> else... but I am afraid I will not find something.
>>
>>>> #define CM_A510_MPP0_7                                 0x00000033
>>>> #define CM_A510_MPP8_15                                0x00445050
>>>> #define CM_A510_MPP16_23                               0x66664040
>>
>
> We forked from DB88AP510-A-P dev board code. Apply the patches from the
> latest CM-A510 U-Boot package
> (http://www.compulab.co.il/products/computer-on-modules/cm-a510/#devres)
> to see the changes log and build instructions.
>
>> By the way, how do you get that resgisters? In my case, I tried to
>> define them as per as Marvell 88AP510 Specification reference. Is it the
>> right place?
>>
>> Best regards,
>>
>> Gabriel
>
>
> Regards,
>
> Dmitry