[U-Boot] [PATCH v8 24/28] armv8/ls2085aqds: NAND boot support

[Scott Wood]

On Tue, 2015-03-24 at 12:47 -0700, York Sun wrote:
> +Booting from NAND
> +-------------------
> +Booting from NAND requires two images, RCW and u-boot-with-spl.bin.
> +The difference between NAND boot RCW image and NOR boot image is the PBI
> +command sequence. Below is one example for PBI commands for QDS.
> +
> +1) CCSR 4-byte write to 0x00e00404, data=0x00000000
> +2) CCSR 4-byte write to 0x00e00400, data=0x1800a000
> +The above two commands set bootloc register to 0x00000000_1800a000 where
> +the u-boot code will be running in OCRAM.
> +
> +3) Block Copy: SRC=0x0107, SRC_ADDR=0x00100000, DEST_ADDR=0x1800a000,
> +BLOCK_SIZE=0x00014000
> +This command copies u-boot image from NAND device into OCRAM. The values need
> +to adjust accordingly.
> +
> +SRC		should match the cfg_rcw_src, the reset config pins. It depends
> +		on the NAND device. See reference manual for cfg_rcw_src.
> +SRC_ADDR	is the offset of u-boot image in NAND device. It should match
> +		CONFIG_SYS_NAND_U_BOOT_OFFS. In the example above, it is 1MB.

Why 1 MiB?

-Scott