[U-Boot] [PATCH 1/1] T102xRDB: Enable ifc nand ecc encode and decode

[Jaiprakash Singh]

From: Jaiprakash Singh <b44839 at freescale.com>

IFC nand ecc encode and decode mode are not correctly
set in CSOR register during nand initialization.Enable
ecc encode/decode in 4-bit mode

Signed-off-by: Jaiprakash Singh <b44839 at freescale.com>
---
 include/configs/T102xRDB.h |    4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/include/configs/T102xRDB.h b/include/configs/T102xRDB.h
index deff617..12082c3 100644
--- a/include/configs/T102xRDB.h
+++ b/include/configs/T102xRDB.h
@@ -395,7 +395,9 @@ unsigned long get_board_ddr_clk(void);
 				| CSOR_NAND_PB(64))	/*Pages Per Block = 64*/
 #define CONFIG_SYS_NAND_BLOCK_SIZE	(512 * 1024)
 #elif defined(CONFIG_T1023RDB)
-#define CONFIG_SYS_NAND_CSOR	(CSOR_NAND_RAL_3	/* RAL 3Bytes */ \
+#define CONFIG_SYS_NAND_CSOR	(CSOR_NAND_ECC_ENC_EN   /* ECC on encode */ \
+				| CSOR_NAND_ECC_DEC_EN  /* ECC on decode */ \
+				| CSOR_NAND_ECC_MODE_4	/* 4-bit ECC */ \
 				| CSOR_NAND_RAL_3	/* RAL 3Bytes */ \
 				| CSOR_NAND_PGS_2K	/* Page Size = 2K */ \
 				| CSOR_NAND_SPRZ_128	/* Spare size = 128 */ \
-- 
1.7.9.5