[U-Boot] cpsw not working with slave2 port defined only

[Belisko Marek]

Hi,

On Tue, May 26, 2015 at 4:51 AM, Mx21 <dillonhua at qq.com> wrote:
> hi marek:
>
>   please check your cpsw_data.slaves   change it to 1
I have already cpsw_data.slaves = 1 as I have only one slave port (port 2).
>
>   and you can set cpsw_data.active_slave = 0 before cpsw_register ,if
> cpsw_data.slaves is 2.
This is when you have more slaves and want to have preferred one to be
primary ethernet.
It's not my case also.

P.S.: please don't top post

BR,

marek
>
>
> ------------------ Original ------------------
> From:  "Belisko Marek";<marek.belisko at gmail.com>;
> Date:  Tue, May 26, 2015 03:30 AM
> To:  "U-Boot Mailing List"<u-boot at lists.denx.de>;
> Subject:  [U-Boot] cpsw not working with slave2 port defined only
>
> Hi,
>
> I have custom am33xx board with phy connected to slave2 port. I
> copy'n'paste cpsw setup from /board/BuR/common/common.c but I'm using
> only slave2 port (RMII mode) so my cpsw_slave_data looks like:
>
> static struct cpsw_slave_data cpsw_slaves[] = {
> {
>                  .slave_reg_ofs  = 0x308,
>                  .sliver_reg_ofs = 0xdc0,
>                  .phy_addr       = 4,
> },
> };
>
> with this configuration cpsw driver can detect link but it cannot
> establish any communication (tested with dhcp command). When I add to
> cpsw_slaves dummy slave1 port definition (with e.g. phy_addr = 0) it
> start working.
>
> mdio bus is working fine (tested with mdio list + mdio read). Pinmux
> is good as it works with dummy slave1 config. Any ideas what I'm doing
> wrong or why only slave2 port cannot be used? I grep whole source code
> but all boards using cpsw use slave1 only or slave1/slave2
> configurations. Many thanks.
>
> BR,
>
> marek
>
> --
> as simple and primitive as possible
> -------------------------------------------------
> Marek Belisko - OPEN-NANDRA
> Freelance Developer
>
> Ruska Nova Ves 219 | Presov, 08005 Slovak Republic
> Tel: +421 915 052 184
> skype: marekwhite
> twitter: #opennandra
> web: http://open-nandra.com
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot



-- 
as simple and primitive as possible
-------------------------------------------------
Marek Belisko - OPEN-NANDRA
Freelance Developer

Ruska Nova Ves 219 | Presov, 08005 Slovak Republic
Tel: +421 915 052 184
skype: marekwhite
twitter: #opennandra
web: http://open-nandra.com