[U-Boot] [PATCH 0/8] ARM: sunxi: Support PSCI for sun6i and sun8i

[Hans de Goede]

Hi,

On 28-05-15 15:25, Chen-Yu Tsai wrote:
> Hi everyone,
>
> I finally got around to rebasing and fixing up my PSCI stuff.
> This series adds PSCI support for sun6i and sun8i. This is
> based on sun7i PSCI support by Marc, and the SMP support
> routines found in both mainline Linux and Allwinner's Android
> kernel.
>
> I've tested this on my Hummingbird A31 board and Ippo q8h v5
> tablet. Given the A23 SMP routines work on the A33 as well,
> I see no reason it would not work, so A33 support is included
> as well, but more testing is always welcome.

Thanks for your work on this! I've merged this
into u-boot-sunxi/next, and tested it on sun6i, sun7i,
sun8i-a23 and sun8i-a33 and it works fine everywhere.

> Patch 1 and 2 address a build failur on sunxi/next I ran into,
> which is related to the new NAND SPL support.

Thanks I've squashed these into the patch causing the build
failures in the first place.

> Patch 3 adds some comments to the sunxi PSCI code, for easier
> reading.
>
> Patch 4 moves sun7i PSCI code aside.
>
> Patch 5 adds sun6i PSCI code. Differences from sun7i are the
> separate PRCM block for power gating/clamps, and support for
> more than 1 secondary CPU core.
>
> Patch 6 enables PSCI for sun6i.
>
> Patch 7 lets sun8i share PSCI code with sun6i. The routines
> are the same, except sun8i does not have power clamps.
>
> Patch 8 enables PSCI for sun8i (A23/A33).

And I've done a normal merge of the rest, and after testing
pushed u-boot-sunxi/next to u-boot-sunxi/master and send
a pull-req to Tom to get this included into u-boot 2015.07

Regards,

Hans