[U-Boot] [PATCH v2 1/2] board_init: Change the logic to setup malloc_base

[Fabio Estevam]

Prior to commit 5ba534d247d418 ("arm: Switch 32-bit ARM to using generic
global_data setup") we used to have assembly code that configured the
malloc_base address.

Since this commit we use the board_init_f_mem() function in C to setup
malloc_base address.

In board_init_f_mem() there was a deliberate choice to support only 
early malloc() or full malloc() in SPL, but not both. 

Adapt this logic to allow both to be used, one after the other, in SPL.

This issue has been observed in a Congatec board, where we need to
retrieve the manufacturing information from the SPI NOR (the SPI API 
calls malloc) prior to configuring the DRAM. In this case as malloc_base
was not configured we always see malloc to fail.

With this change we are able to use malloc in SPL prior to DRAM gets 
initialized.

Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
---
Changes since v1:
- Improve commit log (Simon)

 common/init/board_init.c | 3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)

diff --git a/common/init/board_init.c b/common/init/board_init.c
index e74b63b..1c6126d 100644
--- a/common/init/board_init.c
+++ b/common/init/board_init.c
@@ -50,8 +50,7 @@ ulong board_init_f_mem(ulong top)
 #endif
 	arch_setup_gd(gd_ptr);
 
-#if defined(CONFIG_SYS_MALLOC_F) && \
-	(!defined(CONFIG_SPL_BUILD) || !defined(CONFIG_SYS_SPL_MALLOC_START))
+#if defined(CONFIG_SYS_MALLOC_F)
 	top -= CONFIG_SYS_MALLOC_F_LEN;
 	gd->malloc_base = top;
 #endif
-- 
1.9.1