[U-Boot] [PATCH 00/10] basic support for Allwinner A83T SOC.

Hans de Goede hdegoede at redhat.com
Fri Nov 13 17:52:29 CET 2015


Hi,

On 12-11-15 19:09, Vishnu Patekar wrote:
> This patch series adds basic support for Allwinner A83T SOC.
>
> Allwinner A83T is octa-core cortex-a7 based SoC.
> It's clock control unit and prcm, pinmux are different from previous sun8i
> series.
> Its processor cores are arragned in two clusters 4 cores each,
> similar to A80.
>
> Only basic clocks are enabled pll1, pll5, pll6.
> SMP, display, other peripherals support is not yet supported.

Cool stuff, great work! I've a number of comments, I will reply
to the individual patches with those.

I've tried to get this to run on my own h8_homlet_v2 but
unfortunately I cannot get it to work. My own board does
boot into some chinese top-set-box environment when booting
without a sdcard and connected to a tv. But it does not show
any output on the uart connector at the bottom right of the
board (I've tried with 2 different adapters, including the
one from the Merrii A80 board which has the exact same connector
on the board).

Not having an uart also means that I cannot get the board into
FEL mode (I do have a usb A <-> A cable).

I wonder if my board has a broken uart, or if the system
image uses a different uart by default ?

Have you tried booting with u-boot written to sdcard with
this patch-set ? Does this work, and does the SPL header
get printend on the bottom right uart connector ?

Regards,

Hans



> This enables booting kernel with initramfs, kernel patch v1 have been sent.
> I'll send v2 with comments addressed.
>
> Vishnu Patekar (10):
>    sunxi: Add Machine Support for A83T SOC
>    sunxi: Add support for UART0 in PB pin group on A83T
>    sunxi: power: axp818: add support for axp818 driver
>    sunxi: power: enabled support for axp818
>    sunxi: do not enable smp for A83T
>    sunxi: clk: add basic clocks for A83T
>    sunxi: Add support for Allwinner A83T DRAM
>    sunxi: do not include display for A83T
>    sunxi: dts: sun8i: Add Allwinner A83T dtsi
>    sunxi: Add suport for A83T HomletV2 Board by Allwinner
>
>   arch/arm/cpu/armv7/sunxi/Makefile                  |   7 +
>   arch/arm/cpu/armv7/sunxi/board.c                   |   8 +-
>   arch/arm/cpu/armv7/sunxi/clock_sun8i_a83t.c        | 133 +++++++
>   arch/arm/cpu/armv7/sunxi/cpu_info.c                |   2 +
>   arch/arm/cpu/armv7/sunxi/dram_sun8i_a83t.c         | 424 +++++++++++++++++++++
>   arch/arm/cpu/armv7/sunxi/pmic_bus.c                |  15 +
>   arch/arm/dts/Makefile                              |   2 +
>   arch/arm/dts/sun8i-a83t-allwinner-h8homlet-v2.dts  |  64 ++++
>   arch/arm/dts/sun8i-a83t.dtsi                       | 247 ++++++++++++
>   arch/arm/include/asm/arch-sunxi/clock.h            |   4 +-
>   arch/arm/include/asm/arch-sunxi/clock_sun8i_a83t.h | 304 +++++++++++++++
>   arch/arm/include/asm/arch-sunxi/dram.h             |   2 +
>   arch/arm/include/asm/arch-sunxi/dram_sun8i_a83t.h  | 201 ++++++++++
>   arch/arm/include/asm/arch-sunxi/gpio.h             |   1 +
>   board/sunxi/Kconfig                                |  12 +-
>   board/sunxi/MAINTAINERS                            |   5 +
>   board/sunxi/board.c                                |   8 +
>   configs/h8_homlet_v2_defconfig                     |  26 ++
>   drivers/power/Kconfig                              |  34 +-
>   drivers/power/Makefile                             |   1 +
>   drivers/power/axp818.c                             | 132 +++++++
>   include/axp818.h                                   |  75 ++++
>   include/axp_pmic.h                                 |   3 +
>   include/configs/sun8i.h                            |   2 +
>   include/configs/sunxi-common.h                     |   2 +-
>   25 files changed, 1698 insertions(+), 16 deletions(-)
>   create mode 100644 arch/arm/cpu/armv7/sunxi/clock_sun8i_a83t.c
>   create mode 100644 arch/arm/cpu/armv7/sunxi/dram_sun8i_a83t.c
>   create mode 100644 arch/arm/dts/sun8i-a83t-allwinner-h8homlet-v2.dts
>   create mode 100644 arch/arm/dts/sun8i-a83t.dtsi
>   create mode 100644 arch/arm/include/asm/arch-sunxi/clock_sun8i_a83t.h
>   create mode 100644 arch/arm/include/asm/arch-sunxi/dram_sun8i_a83t.h
>   create mode 100644 configs/h8_homlet_v2_defconfig
>   create mode 100644 drivers/power/axp818.c
>   create mode 100644 include/axp818.h
>


More information about the U-Boot mailing list