[U-Boot] [PATCH] Re-enable setexpr on Raspberry Pi

[Marco Schuster]

This patch re-enables the setexpr command, I don't really understand
why it got excluded in the first place.

setexpr can be used e.g. to implement failed-boot-counters and
failovers to rescue firmware.


Signed-off-by: Marco Schuster <m.schuster91 at googlemail.com>
---
 configs/rpi_2_defconfig | 1 -
 configs/rpi_defconfig   | 1 -
 2 files changed, 2 deletions(-)

diff --git a/configs/rpi_2_defconfig b/configs/rpi_2_defconfig
index 5c9e69a..bd81ee6 100644
--- a/configs/rpi_2_defconfig
+++ b/configs/rpi_2_defconfig
@@ -6,5 +6,4 @@ CONFIG_SYS_PROMPT="U-Boot> "
 # CONFIG_CMD_FLASH is not set
 # CONFIG_CMD_FPGA is not set
 CONFIG_CMD_GPIO=y
-# CONFIG_CMD_SETEXPR is not set
 CONFIG_PHYS_TO_BUS=y
diff --git a/configs/rpi_defconfig b/configs/rpi_defconfig
index b8b267f..5d27909 100644
--- a/configs/rpi_defconfig
+++ b/configs/rpi_defconfig
@@ -6,5 +6,4 @@ CONFIG_SYS_PROMPT="U-Boot> "
 # CONFIG_CMD_FLASH is not set
 # CONFIG_CMD_FPGA is not set
 CONFIG_CMD_GPIO=y
-# CONFIG_CMD_SETEXPR is not set
 CONFIG_PHYS_TO_BUS=y
--
2.6.2