[U-Boot] [Patch V6 18/18] armv8/ls1043a: Enable secondary cores

[Gong Qianyu]

From: Hou Zhiqiang <B48286 at freescale.com>

After the secondary cores enter U-Boot, use CONFIG_ARMV8_MULTIENTRY to
make secondary cores to excute in spin loop.

Signed-off-by: Hou Zhiqiang <B48286 at freescale.com>
Signed-off-by: Mingkai Hu <Mingkai.Hu at freescale.com>
Signed-off-by: Gong Qianyu <Qianyu.Gong at freescale.com>
---
V6:
 - New patch.

 arch/arm/Kconfig                       |  1 +
 arch/arm/cpu/armv8/fsl-layerscape/mp.c | 14 ++++++++++++++
 include/configs/ls1043a_common.h       |  3 +++
 3 files changed, 18 insertions(+)

diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
index 6584e85..6e30a5d 100644
--- a/arch/arm/Kconfig
+++ b/arch/arm/Kconfig
@@ -634,6 +634,7 @@ config TARGET_LS1021ATWR
 config TARGET_LS1043ARDB
 	bool "Support ls1043ardb"
 	select ARM64
+	select ARMV8_MULTIENTRY
 	select SUPPORT_SPL
 	help
 	  Support for Freescale LS1043ARDB platform.
diff --git a/arch/arm/cpu/armv8/fsl-layerscape/mp.c b/arch/arm/cpu/armv8/fsl-layerscape/mp.c
index 1b13d32..0d600db 100644
--- a/arch/arm/cpu/armv8/fsl-layerscape/mp.c
+++ b/arch/arm/cpu/armv8/fsl-layerscape/mp.c
@@ -25,7 +25,11 @@ phys_addr_t determine_mp_bootpg(void)
 int fsl_layerscape_wake_seconday_cores(void)
 {
 	struct ccsr_gur __iomem *gur = (void *)(CONFIG_SYS_FSL_GUTS_ADDR);
+#ifdef CONFIG_FSL_LSCH3
 	struct ccsr_reset __iomem *rst = (void *)(CONFIG_SYS_FSL_RST_ADDR);
+#elif defined(CONFIG_FSL_LSCH2)
+	struct ccsr_scfg __iomem *scfg = (void *)(CONFIG_SYS_FSL_SCFG_ADDR);
+#endif
 	u32 cores, cpu_up_mask = 1;
 	int i, timeout = 10;
 	u64 *table = get_spin_tbl_addr();
@@ -48,13 +52,23 @@ int fsl_layerscape_wake_seconday_cores(void)
 
 	printf("Waking secondary cores to start from %lx\n", gd->relocaddr);
 
+#ifdef CONFIG_FSL_LSCH3
 	gur_out32(&gur->bootlocptrh, (u32)(gd->relocaddr >> 32));
 	gur_out32(&gur->bootlocptrl, (u32)gd->relocaddr);
 	gur_out32(&gur->scratchrw[6], 1);
 	asm volatile("dsb st" : : : "memory");
 	rst->brrl = cores;
 	asm volatile("dsb st" : : : "memory");
+#elif defined(CONFIG_FSL_LSCH2)
+	scfg_out32(&scfg->scratchrw[0], (u32)(gd->relocaddr >> 32));
+	scfg_out32(&scfg->scratchrw[1], (u32)gd->relocaddr);
+	asm volatile("dsb st" : : : "memory");
+	gur_out32(&gur->brrl, cores);
+	asm volatile("dsb st" : : : "memory");
 
+	/* Bootup online cores */
+	scfg_out32(&scfg->corebcr, cores);
+#endif
 	/* This is needed as a precautionary measure.
 	 * If some code before this has accidentally  released the secondary
 	 * cores then the pre-bootloader code will trap them in a "wfe" unless
diff --git a/include/configs/ls1043a_common.h b/include/configs/ls1043a_common.h
index 5b61fcc..d245fc2 100644
--- a/include/configs/ls1043a_common.h
+++ b/include/configs/ls1043a_common.h
@@ -13,6 +13,7 @@
 #define CONFIG_FSL_LAYERSCAPE
 #define CONFIG_FSL_LSCH2
 #define CONFIG_LS1043A
+#define CONFIG_MP
 #define CONFIG_FSL_CLK
 #define CONFIG_GICV2
 
@@ -46,6 +47,8 @@
 #define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY	0
 #define CONFIG_SYS_SDRAM_BASE		CONFIG_SYS_DDR_SDRAM_BASE
 
+#define CPU_RELEASE_ADDR               secondary_boot_func
+
 /* Generic Timer Definitions */
 #define COUNTER_FREQUENCY		25000000	/* 25MHz */
 
-- 
2.1.0.27.g96db324