[U-Boot] [PATCH 1/4] mmc: atmel: Silence debug output

[Marek Vasut]

This driver generates clearly debugging prints when changing clock
speed, so silence those. Furthermore, the driver generates further
prints in case a command fails to complete. The later case woud be
useful, but for eMMC, command 8 can fail and it's not an error but
a part of the specification. Thus, make this debug() as well.

Signed-off-by: Marek Vasut <marex at denx.de>
---
 drivers/mmc/gen_atmel_mci.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/mmc/gen_atmel_mci.c b/drivers/mmc/gen_atmel_mci.c
index 45bcffb..2815e57 100644
--- a/drivers/mmc/gen_atmel_mci.c
+++ b/drivers/mmc/gen_atmel_mci.c
@@ -48,8 +48,8 @@ static unsigned int atmel_mci_get_version(struct atmel_mci *mci)
  */
 static void dump_cmd(u32 cmdr, u32 arg, u32 status, const char* msg)
 {
-	printf("gen_atmel_mci: CMDR %08x (%2u) ARGR %08x (SR: %08x) %s\n",
-		cmdr, cmdr&0x3F, arg, status, msg);
+	debug("gen_atmel_mci: CMDR %08x (%2u) ARGR %08x (SR: %08x) %s\n",
+	      cmdr, cmdr & 0x3F, arg, status, msg);
 }
 
 /* Setup for MCI Clock and Block Size */
@@ -73,7 +73,7 @@ static void mci_set_mode(struct mmc *mmc, u32 hz, u32 blklen)
 			clkodd = clkdiv & 1;
 			clkdiv >>= 1;
 
-			printf("mci: setting clock %u Hz, block size %u\n",
+			debug("mci: setting clock %u Hz, block size %u\n",
 			       bus_hz / (clkdiv * 2 + clkodd + 2), blklen);
 		} else {
 			/* find clkdiv yielding a rate <= than requested */
@@ -81,7 +81,7 @@ static void mci_set_mode(struct mmc *mmc, u32 hz, u32 blklen)
 				if ((bus_hz / (clkdiv + 1) / 2) <= hz)
 					break;
 			}
-			printf("mci: setting clock %u Hz, block size %u\n",
+			debug("mci: setting clock %u Hz, block size %u\n",
 			       (bus_hz / (clkdiv + 1)) / 2, blklen);
 
 		}
-- 
2.1.4