[U-Boot] [PATCH 0/4] sunxi: PSCI support for H3

[Chen-Yu Tsai]

Hi everyone,

This series enables PSCI support for the H3. Like other Allwinner SoCs,
the implementation only supports PSCI 0.1, specifically only secondary
CPU boot/hotplug.

Patch 1 supports the SMTA (previously called TZPC) TrustZone hardware
on H3. This controls non-secure access to some important hardware blocks.

Patch 2 supports the security switch in H3's CCU. This is H3 only. No
other SoCs have this feature.

Patch 3 supports H3 using sun6i PSCI implementation. H3 uses the same
power sequence as sun6i, including the power clamps. This is shown in
Allwinner's SDK, and confirmed / tested by Siarhei.

Patch 4 enables PSCI support for the H3 in Kconfig.


I've only tested booting HYP/SMP on my Orange Pi PC. Hotplugging was not
tested, but should work.


Regards
ChenYu

Chen-Yu Tsai (4):
  sunxi: Support Secure Memory Touch Arbiter (SMTA) in sun8i H3
  sunxi: Support H3 CCU security switches
  sunxi: Support PSCI ops on Allwinner H3
  sunxi: Enable booting non-secure and virtualization for H3

 arch/arm/cpu/armv7/sunxi/Makefile             |  1 +
 arch/arm/cpu/armv7/sunxi/clock.c              |  5 +++++
 arch/arm/cpu/armv7/sunxi/clock_sun6i.c        | 13 +++++++++++++
 arch/arm/cpu/armv7/sunxi/psci_sun6i.S         |  4 ++--
 arch/arm/cpu/armv7/sunxi/tzpc.c               | 11 ++++++++++-
 arch/arm/include/asm/arch-sunxi/clock.h       |  1 +
 arch/arm/include/asm/arch-sunxi/clock_sun6i.h |  7 +++++++
 arch/arm/include/asm/arch-sunxi/tzpc.h        | 13 ++++++++++++-
 board/sunxi/Kconfig                           |  3 +++
 9 files changed, 54 insertions(+), 4 deletions(-)

-- 
2.6.4