[U-Boot] [PATCH] Enable snooping on transactions from CAAM block
Aneesh Bansal
aneesh.bansal at nxp.com
Fri Jan 15 09:08:56 CET 2016
To enable snooping on CAAM transactions following programmign is done
1. Enable core snooping (CCI interface, Core is Slave5 on CCI)
This setting is also required for making the system coherent
2. CAAM IP lies behind SMMU3 in teh system. Configure SMMU3 to do teh following:
a) Program SCR to bypass transactions with stream ID other than taht of CAAM
b_ Program S2CR to change memroy attributes of transactions with CAAM's stream
ID (0x10) to cacheable.
Signed-off-by: Ruchika Gupta <ruchika.gupta at nxp.com>
Signed-off-by: Nitesh Narayan Lal <nitesh.lal at nxp.com>
Signed-off-by: Aneesh Bansal <aneesh.bansal at nxp.com>
---
arch/arm/include/asm/arch-ls102xa/config.h | 1 +
.../include/asm/arch-ls102xa/ls102xa_stream_id.h | 34 ++++++++++++++++++++++
board/freescale/common/ls102xa_stream_id.c | 34 ++++++++++++++++++++++
board/freescale/ls1021aqds/ls1021aqds.c | 4 +++
board/freescale/ls1021atwr/ls1021atwr.c | 4 +++
5 files changed, 77 insertions(+)
diff --git a/arch/arm/include/asm/arch-ls102xa/config.h b/arch/arm/include/asm/arch-ls102xa/config.h
index f066480..f14ea2f 100644
--- a/arch/arm/include/asm/arch-ls102xa/config.h
+++ b/arch/arm/include/asm/arch-ls102xa/config.h
@@ -38,6 +38,7 @@
#define CONFIG_SYS_LS102XA_XHCI_USB1_ADDR (CONFIG_SYS_IMMR + 0x02100000)
#define CONFIG_SYS_LS102XA_USB1_ADDR \
(CONFIG_SYS_IMMR + CONFIG_SYS_LS102XA_USB1_OFFSET)
+#define CONFIG_SYS_SMMU3_ADDR (CONFIG_SYS_IMMR + 0x300000)
#define CONFIG_SYS_FSL_SEC_OFFSET 0x00700000
#define CONFIG_SYS_LS102XA_USB1_OFFSET 0x07600000
diff --git a/arch/arm/include/asm/arch-ls102xa/ls102xa_stream_id.h b/arch/arm/include/asm/arch-ls102xa/ls102xa_stream_id.h
index fa571b3..68e4e02 100644
--- a/arch/arm/include/asm/arch-ls102xa/ls102xa_stream_id.h
+++ b/arch/arm/include/asm/arch-ls102xa/ls102xa_stream_id.h
@@ -6,6 +6,39 @@
#ifndef __FSL_LS102XA_STREAM_ID_H_
#define __FSL_LS102XA_STREAM_ID_H_
+#define CONFIG_SMMU_NSCR_OFFSET 0x400
+#define CONFIG_SMMU_SMR_OFFSET 0x800
+#define CONFIG_SMMU_S2CR_OFFSET 0xc00
+
+#define SMMU_NSCR_CLIENTPD_SHIFT 0
+#define SMMU_NSCR_MTCFG_SHIFT 20
+
+#define SMR_SMR_VALID_SHIFT 31
+#define SMR_ID_MASK 0x7fff
+#define SMR_MASK_SHIFT 16
+
+#define S2CR_WACFG_SHIFT 22
+#define S2CR_WACFG_MASK 0x3
+#define S2CR_WACFG_WRITE_ALLOCATE 0x2
+
+#define S2CR_RACFG_SHIFT 20
+#define S2CR_RACFG_MASK 0x3
+#define S2CR_RACFG_READ_ALLOCATE 0x2
+
+#define S2CR_TYPE_SHIFT 16
+#define S2CR_TYPE_MASK 0x3
+#define S2CR_TYPE_BYPASS 0x01
+
+#define S2CR_MEM_ATTR_SHIFT 12
+#define S2CR_MEM_ATTR_MASK 0xf
+#define S2CR_MEM_ATTR_CACHEABLE 0xa
+
+#define S2CR_MTCFG 0x00000800
+
+#define S2CR_SHCFG_SHIFT 8
+#define S2CR_SHCFG_MASK 0x3
+#define S2CR_SHCFG_OUTER_CACHEABLE 0x1
+#define S2CR_SHCFG_INNER_CACHEABLE 0x2
#include <fsl_sec.h>
@@ -71,4 +104,5 @@ struct smmu_stream_id {
void ls1021x_config_caam_stream_id(struct liodn_id_table *tbl, int size);
void ls102xa_config_smmu_stream_id(struct smmu_stream_id *id, uint32_t num);
+void ls1021x_config_smmu3(uint32_t liodn);
#endif
diff --git a/board/freescale/common/ls102xa_stream_id.c b/board/freescale/common/ls102xa_stream_id.c
index f434269..2b12a8c 100644
--- a/board/freescale/common/ls102xa_stream_id.c
+++ b/board/freescale/common/ls102xa_stream_id.c
@@ -31,3 +31,37 @@ void ls1021x_config_caam_stream_id(struct liodn_id_table *tbl, int size)
out_le32((uint32_t *)(tbl[i].reg_offset), liodn);
}
}
+
+void ls1021x_config_smmu3(uint32_t liodn)
+{
+ uint32_t *addr;
+ u32 smr, s2cr, nscr;
+
+ addr = (uint32_t *)(CONFIG_SYS_SMMU3_ADDR + CONFIG_SMMU_NSCR_OFFSET);
+ /* SMMU NSCR configuration */
+ nscr = in_le32(addr);
+
+ nscr = nscr & ~(1 << SMMU_NSCR_CLIENTPD_SHIFT |
+ 1 << SMMU_NSCR_MTCFG_SHIFT);
+ out_le32(addr, nscr);
+
+ /* SMMU SMR configuration */
+ addr = (uint32_t *)(CONFIG_SYS_SMMU3_ADDR + CONFIG_SMMU_SMR_OFFSET);
+
+ smr = 0;
+ smr = smr & (~(SMR_ID_MASK << SMR_MASK_SHIFT));
+ smr = smr | (1 << SMR_SMR_VALID_SHIFT) | liodn;
+
+ out_le32(addr, smr);
+
+ /* SMMU S2CR configuration */
+ addr = (uint32_t *)(CONFIG_SYS_SMMU3_ADDR + CONFIG_SMMU_S2CR_OFFSET);
+ s2cr = (S2CR_WACFG_WRITE_ALLOCATE << S2CR_WACFG_SHIFT) |
+ (S2CR_RACFG_READ_ALLOCATE << S2CR_RACFG_SHIFT) |
+ (S2CR_TYPE_BYPASS << S2CR_TYPE_SHIFT) |
+ (S2CR_MEM_ATTR_CACHEABLE << S2CR_MEM_ATTR_SHIFT) |
+ S2CR_MTCFG |
+ (S2CR_SHCFG_OUTER_CACHEABLE << S2CR_SHCFG_SHIFT);
+
+ out_le32(addr, s2cr);
+}
diff --git a/board/freescale/ls1021aqds/ls1021aqds.c b/board/freescale/ls1021aqds/ls1021aqds.c
index be3358a..ca1ea61 100644
--- a/board/freescale/ls1021aqds/ls1021aqds.c
+++ b/board/freescale/ls1021aqds/ls1021aqds.c
@@ -481,6 +481,10 @@ int board_init(void)
ARRAY_SIZE(sec_liodn_tbl));
ls102xa_config_smmu_stream_id(dev_stream_id,
ARRAY_SIZE(dev_stream_id));
+ /* Configure SMMU3 to make transactions with CAAM stream ID
+ * as cacheable
+ */
+ ls1021x_config_smmu3(0x10);
#ifdef CONFIG_LAYERSCAPE_NS_ACCESS
enable_layerscape_ns_access();
diff --git a/board/freescale/ls1021atwr/ls1021atwr.c b/board/freescale/ls1021atwr/ls1021atwr.c
index 8eaff5f..ae62bca 100644
--- a/board/freescale/ls1021atwr/ls1021atwr.c
+++ b/board/freescale/ls1021atwr/ls1021atwr.c
@@ -528,6 +528,10 @@ int board_init(void)
ARRAY_SIZE(sec_liodn_tbl));
ls102xa_config_smmu_stream_id(dev_stream_id,
ARRAY_SIZE(dev_stream_id));
+ /* Configure SMMU3 to make transactions with CAAM stream ID
+ * as cacheable
+ */
+ ls1021x_config_smmu3(0x10);
#ifdef CONFIG_LAYERSCAPE_NS_ACCESS
enable_layerscape_ns_access();
--
1.8.1.4
More information about the U-Boot
mailing list