[U-Boot] [PATCH v6 00/10] add support for atheros ath79 based SOCs

[Marek Vasut]

On Monday, January 04, 2016 at 12:06:17 PM, Wills Wang wrote:
> These series of patch add support for atheros ath79 based SOCs in u-boot,
> at the present moment it's just available for ar933x and qca953x chip.
> 
> Changes in v6:
> - Remove useless "else"
> - Move ar933x as separate patch
> - Add get_bootstrap in reset.c
> - Use map_physmem instead of KSEG1ADDR
> - Add arch_cpu_init for detect SOC type for early
> - Define magic value in ddr.c
> - Remove wait loop in putc and getc
> - Use map_physmem instead of KSEG1ADDR
> - Add rrw_delay in ath79_spi_priv for more accurate timing
> - Remove ath79_spi_delay
> - Calculate delay in ath79_spi_set_speed
> - Convert SZ_XXX into hex in ap121.h
> - Remove useless CONFIG_SYS_INIT_SP_OFFSET in ap121.h
> - Add board_early_init_f for DDR and pin initialization
> - Select UART and SPI in ap121_defconfig
> - Add support for qca953x

I wanted to try this patchset, so I picked [1], since I didn't feel like fishing
out patches from the list. Especially since this wasn't sent as a series, but as
separate patches, which makes things annoying.

The [1] does not even compile, which is surprising. I would expect that if you 
submit patches, you would at least compile-test them. Sigh. I needed this patch:

---8<---
diff --git a/arch/mips/mach-ath79/cpu.c b/arch/mips/mach-ath79/cpu.c
index 2952679..140c65c 100644
--- a/arch/mips/mach-ath79/cpu.c
+++ b/arch/mips/mach-ath79/cpu.c
@@ -9,8 +9,8 @@
 #include <asm/io.h>
 #include <asm/addrspace.h>
 #include <asm/types.h>
-#include <asm/arch/ath79.h>
-#include <asm/arch/ar71xx_regs.h>
+#include <mach/ath79.h>
+#include <mach/ar71xx_regs.h>
 
 struct ath79_soc_desc {
        enum ath79_soc_type soc;
diff --git a/arch/mips/mach-ath79/reset.c b/arch/mips/mach-ath79/reset.c
index 410b900..fe32d80 100644
--- a/arch/mips/mach-ath79/reset.c
+++ b/arch/mips/mach-ath79/reset.c
@@ -9,7 +9,7 @@
 #include <asm/io.h>
 #include <asm/addrspace.h>
 #include <asm/types.h>
-#include <asm/arch/ath79.h>
+#include <mach/ath79.h>
 #include <mach/ar71xx_regs.h>
                                                                                                                                                  
 void _machine_restart(void)
--->8---

Once I managed to fix things, I compiled ap121. I tried booting it on arduino
yun (ar9331), but it hung in start.S in setup_c0_status . If I comment this
out, it hangs in lowlevel_init, right at the beginning. That's where I gave up.

[1] http://git.denx.de/?p=u-boot/u-boot-
mips.git;a=shortlog;h=refs/heads/mips_ath79_v6

Best regards,
Marek Vasut