[U-Boot] Banan Pro (ahci-sunxi) SATA port stopped working after switching to U-Boot v2016.01

Markus Baier u-boot_list at baier-network.de
Thu Jan 21 00:34:25 CET 2016


Am 19.01.2016 um 18:12 schrieb Tom Rini:
 > On Sun, Jan 17, 2016 at 09:44:53PM +0100, Markus Baier wrote:
 >
 >> Hello,
 >>
 >> tonight I switched  to the new U-Boot v2016.01
 >> on my Banana Pro system.
 >> I compiled u-boot, like I did with all the working
 >> versions before, with:
 >> make Bananapro_defconfig
 >> make
 >>
 >> But with the new U-Boot installed the SATA Port
 >> did not work anymore.
 >> The Kernel is the same 4.0.9-gentoo as I used before
 >> with the last U-Boot Release v2015.10
 >>
 >> dmesg show me the following error in the kernel log:
 >> [    1.925032] ahci-sunxi 1c18000.sata: PHY power up failed.
 >> [    1.930661] ahci-sunxi: probe of 1c18000.sata failed with error -5
 >>
 >> I also see now SATA message at the U-Boot bootscreen,
 >> the v2015.10 shows me that a SATA Port was recognized
 >> by the U-Boot loader.
 >
 > Can you please use git bisect to determine which commit broke this?
 > Thanks!

Hi,

thanks for the advice, I have found the bad commit,
it is -> 02cc27c74f9b884b538bcd1b93342a4c05b5d608
sunxi: power: Change axp209 LDO3 and LDO4 default to disabled

after that I tried the v2016.01 release again, but changed
the two lines in config AXP_ALDO3_VOLT and config AXP_ALDO4_VOLT
back to their old values, now the SATA Port is working again.


Regards
Markus Baier


More information about the U-Boot mailing list