[U-Boot] [PATCH 00/17] arm: ls1021atwr: Convert to use driver model TSEC driver

Bin Meng bmeng.cn at gmail.com
Tue Jan 26 03:45:14 CET 2016


On Wed, Jan 20, 2016 at 1:16 AM, york sun <york.sun at nxp.com> wrote:
> On 01/17/2016 09:16 PM, Bin Meng wrote:
>> Joe, York,
>>
>> On Tue, Jan 12, 2016 at 2:41 PM, Bin Meng <bmeng.cn at gmail.com> wrote:
>>> This series adds driver model ethernet support to the Freescale
>>> TSEC ethernet driver and convert ls1021atwr board to use it.
>>>
>>> Enable the support in the ls1021atwr_nor_defconfig and
>>> ls1021atwr_nor_lpuart_defconfig configurations.
>>>
>>>
>>> Bin Meng (17):
>>>   powerpc: bsc9132qds: Do not wrap pci_eth_init() with CONFIG_TSEC_ENET
>>>   powerpc: c29xpcie: Do not wrap pci_eth_init() with CONFIG_TSEC_ENET
>>>   powerpc: mpc8572ds: Do not wrap pci_eth_init() with CONFIG_TSEC_ENET
>>>   powerpc: mpc8548cds: Do not wrap pci_eth_init() with CONFIG_TSEC_ENET
>>>   powerpc: p1010rdb: Do not wrap pci_eth_init() with CONFIG_TSEC_ENET
>>>   arm: ls1021atwr: Do not wrap pci_eth_init() with CONFIG_TSEC_ENET
>
> I think separating TSEC from PCI eth is correct.
>
>>>   net: tsec: fsl_mdio: Fix several cosmetic issues
>>>   net: tsec: Move rx_idx and tx_idx to struct tsec_private
>>>   net: tsec: Move rxbd and txbd to struct tsec_private
>
> I don't see problem with above change. I didn't test them though.
>

Thanks York.

>>>   net: tsec: Adjust orders to avoid forward declaration of tsec_send()
>>>   net: tsec: Use tsec_private pointer as the parameter for internal
>>>     routines
>>>   doc: dt-bindings: Describe Freescale TSEC ethernet controller
>>>   net: tsec: Add driver model ethernet support
>>>   net: tsec: Use priv->tbiaddr to initialize TBI PHY address
>>>   arm: ls102xa: Rewrite the logic of ft_fixup_enet_phy_connect_type()

Hi Joe, I see this series are assigned to you. If the first 15 patches
are OK, please apply it directly so that I can save some time
including them in v2.

>>>   arm: ls1021atwr: Disable CONFIG_E1000 temporarily
>>>   arm: ls1021atwr: Convert to use driver model TSEC driver
>

Since York has some comments regarding to CONFIG_E1000, I will work on
the remaining 2 patches in v2, together with DM PCI conversion.

> I haven't tested your patch. Just a reminder, please keep it in mind to have
> "git bisect" always working, in case we need to find something later. My
> previous comment on disabling E1000 for ls1021atwr still stands.
>
> York
>

Regards,
Bin


More information about the U-Boot mailing list