[U-Boot] [PATCH v2 0/7] net: add support for phy speed limitation

[Joe Hershberger]

On Wed, Jan 27, 2016 at 10:23 AM, Alexey Brodkin
<Alexey.Brodkin at synopsys.com> wrote:
> Hi Joe,
>
> On Tue, 2016-01-19 at 07:02 +0000, Alexey Brodkin wrote:
>> Hi Joe,
>>
>> On Wed, 2016-01-13 at 16:59 +0300, Alexey Brodkin wrote:
>> > In some cases Ethernet PHY and network itself might support speeds
>> > which are not supported by Ethernet controller (MAC).
>> >
>> > To support that kind of situation it is required to force limit
>> > PHY so it is not configured for unsupported mode or even if PHY
>> > autonegotiated too high speed it will be reconfigured for slower mode.
>> >
>> > Note this series is v2 because v1 patches were sent separately not being
>> > aranged in series. And now I'm putting all patches in one series
>> > and marking it v2 even though no changes were done in patches itself.
>> >
>> > Alexey Brodkin (4):
>> >   drivers/net/phy: introduce phy_set_supported()
>> >   include/net.h: add max_speed member in struct eth_pdata
>> >   net/designware: do explicit port selection for 1Gb mode
>> >   net/designware: add support of max-speed device tree property
>> >
>> > Florian Fainelli (2):
>> >   net: phy: ensure Gigabit features are masked off if requested
>> >   net: phy: breakdown PHY_*_FEATURES defines
>> >
>> > Sascha Hauer (1):
>> >   net: phy: genphy: Allow overwriting features
>> >
>> >  drivers/net/designware.c | 16 +++++++++-
>> >  drivers/net/designware.h |  1 +
>> >  drivers/net/phy/phy.c    | 77 ++++++++++++++++++++++++++++++++++--------------
>> >  include/net.h            |  2 ++
>> >  include/phy.h            | 23 ++++++++++-----
>> >  5 files changed, 89 insertions(+), 30 deletions(-)
>>
>> Please treat this as a polite reminder to review
>> that series sometime soon.
>
> Thank you for reviewing that series.
> I'm wondering who's going to pick it up?

I'm picking it up now and build testing it.

Thanks,
-Joe