[U-Boot] [PATCH] test/py: make each unit test a pytest

[Stephen Warren]

On 01/29/2016 11:23 AM, Simon Glass wrote:
> Hi Stephen,
>
> On 28 January 2016 at 22:08, Stephen Warren <swarren at wwwdotorg.org> wrote:
>> On 01/28/2016 08:52 PM, Simon Glass wrote:
>>> Hi Stephen,
>>>
>>> On 28 January 2016 at 16:45, Stephen Warren <swarren at wwwdotorg.org> wrote:
>>>> From: Stephen Warren <swarren at nvidia.com>
>>>>
>>>> A custom fixture named ut_subtest is implemented which is parametrized
>>>> with the names of all unit tests that the U-Boot binary supports. This
>>>> causes each U-Boot unit test to be exposes as a separate pytest. In turn,
>>>> this allows more fine-grained pass/fail counts and test selection, e.g.:
>>>>
>>>> test.py --bd sandbox -k ut_dm_usb
>>>>
>>>> ... will run about 8 tests at present.
>>>>
>>>> Signed-off-by: Stephen Warren <swarren at nvidia.com>
>>>> ---
>>>> This depends on at least my recently sent "test/py: run C-based unit tests".
>>>>
>>>>   test/py/conftest.py      | 105 ++++++++++++++++++++++++++++++++++++-----------
>>>>   test/py/tests/test_ut.py |  14 +++----
>>>>   2 files changed, 86 insertions(+), 33 deletions(-)
>>>
>>> This seems a bit extreme. It might be better to move the remaining
>>> three commands under the 'ut' subcommand. Then all unit tests would be
>>> visible from the 'ut' help...
>>
>> I'm not sure what you mean by "extreme"? Do you mean you don't want each
>> unit test exposed as a separate pytest? I thought based on our previous
>> conversation that was exactly what you wanted. If not, I'm not sure what
>> the deficiency in the current code is; either all the dm subtests are
>> executed at once by a single pytest with a single overall status, or
>> they're each a separate pytest with individual status. Any grouping
>> that's in between those seems like it would be entirely arbitrary?
>
> I mean that there might be a simpler way to find out what unit tests
> are available in U-Boot rather than using objdump! Can the 'ut'
> command itself report this?

Well, the Python code could parse the ELF binary itself... :-)

We can't parse the source code to determine the test list, since it'd be 
hard to determine which tests were actually compiled in (based on 
.config feature support), v.s. which were simply written but not compiled.

Perhaps we could add a new command-line option to U-Boot that /only/ 
prints out the list of support unit tests. That would mean executing the 
U-Boot binary on the host to determine the list though, which would 
limit the approach to sandbox; it couldn't ever work if we enabled unit 
tests on real HW. objdump should work in that scenario.

Or perhaps the build process could dump out a list of enabled unit 
tests, so test/py could simply read that file. At least that would push 
the objdump usage into the build process where it's basically guaranteed 
we have an objdump binary, plus we can use $(CROSS_COMPILE)objdump which 
would be better for cross-compiled binaries...