[U-Boot] [PATCH v2 2/7] spl: nand: rename the SYS_NAND_U_BOOT_OFFS Kconfig option

[Scott Wood]

On Wed, 2016-06-01 at 13:23 +0200, Boris Brezillon wrote:
> The SYS_NAND_U_BOOT_OFFS is quite generic, but the Kconfig entry is forced
> to explicitly depend on platforms that are not already defining it in their
> include/configs/<board>.h header.
> 
> Rename this Kconfig option into SPL_NAND_U_BOOT_OFFS, remove the dependency
> on NAND_SUNXI and make it dependent on SPL selection.
> 
> common/spl/spl_nand.c now sets CONFIG_SYS_NAND_U_BOOT_OFFS to
> CONFIG_SPL_NAND_U_BOOT_OFFS only when it's undefined. This way we stay
> compatible with the existing behavior.
> 
> Signed-off-by: Boris Brezillon <boris.brezillon at free-electrons.com>
> Acked-by: Hans de Goede <hdegoede at redhat.com>
> ---
>  common/spl/spl_nand.c             | 4 ++++
>  drivers/mtd/nand/Kconfig          | 9 +++++----
>  drivers/mtd/nand/sunxi_nand_spl.c | 8 ++++----
>  3 files changed, 13 insertions(+), 8 deletions(-)
> 
> diff --git a/common/spl/spl_nand.c b/common/spl/spl_nand.c
> index bbd9546..612bd4a 100644
> --- a/common/spl/spl_nand.c
> +++ b/common/spl/spl_nand.c
> @@ -10,6 +10,10 @@
>  #include <asm/io.h>
>  #include <nand.h>
>  
> +#ifndef CONFIG_SYS_NAND_U_BOOT_OFFS
> +#define CONFIG_SYS_NAND_U_BOOT_OFFS CONFIG_SPL_NAND_U_BOOT_OFFS
> +#endif
[snip]
> -# Enhance depends when converting drivers to Kconfig which use this config
> -config SYS_NAND_U_BOOT_OFFS
> +if SPL
> +
> +# This option should be used in replacement of CONFIG_SYS_NAND_U_BOOT_OFFS.
> +# CONFIG_SYS_NAND_U_BOOT_OFFS is still preferred if defined.
> +config SPL_NAND_U_BOOT_OFFS
>  	hex "Location in NAND to read U-Boot from"
>  	default 0x8000 if NAND_SUNXI
> -	depends on NAND_SUNXI
>  	help
>  	Set the offset from the start of the nand where u-boot should be
>  	loaded from.

This doesn't work.  CONFIG_SPL_NAND_U_BOOT_OFFS will always be defined when SPL is defined, and the user will be forced to enter a value before kconfig will continue (or kconfig will error out in an automated build).

If you want to do this there needs to be a separate bool config that controls whether the hex config exists.  And there'd be no need to rename hex symbol.

-Scott