[U-Boot] [PATCH v3 1/7] spl: nand: sunxi: remove support for so-called 'syndrome' mode
Boris Brezillon
boris.brezillon at free-electrons.com
Mon Jun 6 10:16:56 CEST 2016
The sunxi SPL NAND controller driver supports use 'BootROM'-like configs,
that is, configs where the ECC bytes and real data are interleaved in the
page instead of putting ECC bytes in the OOB area.
Doing that has several drawbacks:
- since you're interleaving data and ECC bytes you can't use the whole page
otherwise you might override the bad block marker with non-FF bytes.
- to solve the bad block marker problem, the ROM code supports partially
using the page, but this introduces a huge penalty both in term of read
speed and NAND memory usage. While this is fine for rather small
binaries(like the SPL one which is at maximum 24KB large), it becomes
non-negligible for the bootloader image (several hundred of KB).
- auto-detection of the page size is not reliable (this is in my opinion
the biggest problem). If you get the page size wrong, you'll end up
reading data at a different offset than what was specified by the caller
and the reading may succeed (if valid data were written at this address).
For all those reasons I think it's wiser to completely remove support for
'syndrome' configs. If we ever need to support it again, then I'd recommend
specifying all the config parameters through Kconfig options.
Signed-off-by: Boris Brezillon <boris.brezillon at free-electrons.com>
Acked-by: Hans de Goede <hdegoede at redhat.com>
---
drivers/mtd/nand/sunxi_nand_spl.c | 56 ++++++++++-----------------------------
1 file changed, 14 insertions(+), 42 deletions(-)
diff --git a/drivers/mtd/nand/sunxi_nand_spl.c b/drivers/mtd/nand/sunxi_nand_spl.c
index b0e07aa..1739da2 100644
--- a/drivers/mtd/nand/sunxi_nand_spl.c
+++ b/drivers/mtd/nand/sunxi_nand_spl.c
@@ -119,9 +119,6 @@ const uint16_t random_seed[128] = {
0x7c57, 0x0fbe, 0x46ce, 0x4939, 0x6b17, 0x37bb, 0x3e91, 0x76db,
};
-/* random seed used for syndrome calls */
-const uint16_t random_seed_syndrome = 0x4a80;
-
#define MAX_RETRIES 10
static int check_value_inner(int offset, int expected_bits,
@@ -183,7 +180,7 @@ void nand_init(void)
}
static int nand_read_page(int page_size, int ecc_strength, int ecc_page_size,
- int addr_cycles, uint32_t real_addr, dma_addr_t dst, int syndrome)
+ int addr_cycles, uint32_t real_addr, dma_addr_t dst)
{
uint32_t val;
int i, ecc_off = 0;
@@ -209,17 +206,11 @@ static int nand_read_page(int page_size, int ecc_strength, int ecc_page_size,
page = real_addr / page_size;
column = real_addr % page_size;
- if (syndrome)
- column += (column / ecc_page_size) * ecc_off;
-
/* clear ecc status */
writel(0, SUNXI_NFC_BASE + NFC_ECC_ST);
/* Choose correct seed */
- if (syndrome)
- rand_seed = random_seed_syndrome;
- else
- rand_seed = random_seed[page % 128];
+ rand_seed = random_seed[page % 128];
writel((rand_seed << 16) | NFC_ECC_RANDOM_EN | NFC_ECC_EN
| NFC_ECC_PIPELINE | (ecc_mode << 12),
@@ -228,9 +219,8 @@ static int nand_read_page(int page_size, int ecc_strength, int ecc_page_size,
val = readl(SUNXI_NFC_BASE + NFC_CTL);
writel(val | NFC_CTL_RAM_METHOD, SUNXI_NFC_BASE + NFC_CTL);
- if (!syndrome)
- writel(page_size + (column / ecc_page_size) * ecc_off,
- SUNXI_NFC_BASE + NFC_SPARE_AREA);
+ writel(page_size + (column / ecc_page_size) * ecc_off,
+ SUNXI_NFC_BASE + NFC_SPARE_AREA);
flush_dcache_range(dst, ALIGN(dst + ecc_page_size, ARCH_DMA_MINALIGN));
@@ -266,7 +256,7 @@ static int nand_read_page(int page_size, int ecc_strength, int ecc_page_size,
writel(NFC_SEND_CMD1 | NFC_SEND_CMD2 | NFC_DATA_TRANS |
NFC_PAGE_CMD | NFC_WAIT_FLAG |
((addr_cycles - 1) << NFC_ADDR_NUM_OFFSET) |
- NFC_SEND_ADR | NFC_DATA_SWAP_METHOD | (syndrome ? NFC_SEQ : 0),
+ NFC_SEND_ADR | NFC_DATA_SWAP_METHOD,
SUNXI_NFC_BASE + NFC_CMD);
if (!check_value(SUNXI_NFC_BASE + NFC_ST, NFC_ST_DMA_INT_FLAG,
@@ -292,7 +282,7 @@ static int nand_read_page(int page_size, int ecc_strength, int ecc_page_size,
}
static int nand_read_ecc(int page_size, int ecc_strength, int ecc_page_size,
- int addr_cycles, uint32_t offs, uint32_t size, void *dest, int syndrome)
+ int addr_cycles, uint32_t offs, uint32_t size, void *dest)
{
void *end = dest + size;
@@ -301,16 +291,14 @@ static int nand_read_ecc(int page_size, int ecc_strength, int ecc_page_size,
for ( ;dest < end; dest += ecc_page_size, offs += ecc_page_size) {
if (nand_read_page(page_size, ecc_strength, ecc_page_size,
- addr_cycles, offs, (dma_addr_t)dest,
- syndrome))
+ addr_cycles, offs, (dma_addr_t)dest))
return -1;
}
return 0;
}
-static int nand_read_buffer(uint32_t offs, unsigned int size, void *dest,
- int syndrome)
+static int nand_read_buffer(uint32_t offs, unsigned int size, void *dest)
{
const struct {
int page_size;
@@ -337,7 +325,7 @@ static int nand_read_buffer(uint32_t offs, unsigned int size, void *dest,
nand_configs[i].ecc_strength,
nand_configs[i].ecc_page_size,
nand_configs[i].addr_cycles,
- offs, size, dest, syndrome) == 0) {
+ offs, size, dest) == 0) {
debug("success\n");
nand_config = i;
return 0;
@@ -351,48 +339,32 @@ static int nand_read_buffer(uint32_t offs, unsigned int size, void *dest,
nand_configs[nand_config].ecc_strength,
nand_configs[nand_config].ecc_page_size,
nand_configs[nand_config].addr_cycles,
- offs, size, dest, syndrome);
+ offs, size, dest);
}
int nand_spl_load_image(uint32_t offs, unsigned int size, void *dest)
{
-#if CONFIG_SYS_NAND_U_BOOT_OFFS == CONFIG_SPL_PAD_TO
- /*
- * u-boot-dtb.bin appended to SPL, use syndrome (like the BROM does)
- * and try different erase block sizes to find the backup.
- */
- const uint32_t boot_offsets[] = {
- 0 * 1024 * 1024 + CONFIG_SYS_NAND_U_BOOT_OFFS,
- 1 * 1024 * 1024 + CONFIG_SYS_NAND_U_BOOT_OFFS,
- 2 * 1024 * 1024 + CONFIG_SYS_NAND_U_BOOT_OFFS,
- 4 * 1024 * 1024 + CONFIG_SYS_NAND_U_BOOT_OFFS,
- };
- const int syndrome = 1;
-#else
/*
- * u-boot-dtb.bin on its own partition, do not use syndrome, u-boot
- * partition sits after 2 eraseblocks (spl, spl-backup), look for
- * backup u-boot 1 erase block further.
+ * u-boot partition sits after 2 eraseblocks (spl, spl-backup), look
+ * for backup u-boot 1 erase block further.
*/
const uint32_t eraseblock_size = CONFIG_SYS_NAND_U_BOOT_OFFS / 2;
const uint32_t boot_offsets[] = {
CONFIG_SYS_NAND_U_BOOT_OFFS,
CONFIG_SYS_NAND_U_BOOT_OFFS + eraseblock_size,
};
- const int syndrome = 0;
-#endif
int i;
if (offs == CONFIG_SYS_NAND_U_BOOT_OFFS) {
for (i = 0; i < ARRAY_SIZE(boot_offsets); i++) {
if (nand_read_buffer(boot_offsets[i], size,
- dest, syndrome) == 0)
+ dest) == 0)
return 0;
}
return -1;
}
- return nand_read_buffer(offs, size, dest, syndrome);
+ return nand_read_buffer(offs, size, dest);
}
void nand_deselect(void)
--
2.7.4
More information about the U-Boot
mailing list