[U-Boot] [PATCH v3 00/11] armv8: ls2080aqds: Enable QSPI boot support

[Yao Yuan]

On 06/07/2016 02:41 AM, York Sun wrote:
> On 06/06/2016 03:53 AM, Yuan Yao wrote:
> > From: Yuan Yao <yao.yuan at nxp.com>
> >
> > This patch adds QSPI boot support for LS2080AQDS board.
> > The QSPI boot image need to be programmed into the QSPI flash first.
> > Then we can switch to booting from QSPI memory space.
> >
> > Yuan Yao (11):
> >   armv8: ls2080aqds: Select QSPI CLK div via SCFG
> >   configs: ls2080a_common: Remove duplicate NOR configs
> >   configs: ls2080aqds: disable IFC NOR & QIXIS when QSPI enable
> >   configs: ls2080aqds: Enable QSPI flash support
> >   dm: dts: ls2080aqds: Add QSPI dts node
> >   armv8: ls2080aqds: Config QSPI pin mux via FPGA in NAND boot
> >   configs: ls2080a: Increase load image len in NAND boot
> >   ls2080aqds_nand_defconfig: Enable QSPI & its dependence
> >   armv8: ls2080aqds: Enable QSPI boot support
> > 	Rebase in v3.
> >   drivers: i2c: mxc: Add early init
> > 	New add in v3.
> >   board: freescale: ls2080aqds: Enable early I2C access for QSPI boot
> >   	New add in v3.
> 
> Yuan,
> 
> Do you think you can reorder these patches so that early i2c init can be in front
> of disabling IFC? Then you don't have to use fixed clk at all. I am thinking if we
> run git bisect and this set could break QSPI boot if sys clk is other than 100MHz.
> 
Sorry for the mistake, it's a good suggestion.
I will resend the patch soon.
Thanks for your review.