[U-Boot] [PATCH] ehci: mx7： Fix OTG ID detection

[Peng Fan]

From: Ye Li <ye.li at nxp.com>

1. The offset for phy_status register in usbnc_regs is not correct.
2. We should clear the USBNC_PHYCFG2_ACAENB bit to enable the OTG ID detection,
   not set it.  When the bit is set, the ACA Resistance Detection is enabled,
   which disables the OTG ID detection, because the internal pull up is off.

Signed-off-by: Peng Fan <peng.fan at nxp.com>
Signed-off-by: Ye Li <ye.li at nxp.com>
Cc: Marek Vasut <marex at denx.de>
Cc: Mateusz Kulikowski <mateusz.kulikowski at gmail.com>
Cc: Stefan Agner <stefan at agner.ch>
---
 drivers/usb/host/ehci-mx6.c | 10 +++++++---
 1 file changed, 7 insertions(+), 3 deletions(-)

diff --git a/drivers/usb/host/ehci-mx6.c b/drivers/usb/host/ehci-mx6.c
index bb48d0d..922ef29 100644
--- a/drivers/usb/host/ehci-mx6.c
+++ b/drivers/usb/host/ehci-mx6.c
@@ -194,8 +194,9 @@ struct usbnc_regs {
 	u32 reserve1[10];
 	u32 phy_cfg1;
 	u32 phy_cfg2;
+	u32 reserve2[1];
 	u32 phy_status;
-	u32 reserve2[4];
+	u32 reserve3[4];
 	u32 adp_cfg1;
 	u32 adp_cfg2;
 	u32 adp_status;
@@ -207,8 +208,11 @@ static void usb_power_config(int index)
 			(0x10000 * index) + USBNC_OFFSET);
 	void __iomem *phy_cfg2 = (void __iomem *)(&usbnc->phy_cfg2);
 
-	/* Enable usb_otg_id detection */
-	setbits_le32(phy_cfg2, USBNC_PHYCFG2_ACAENB);
+	/*
+	 * Clear the ACAENB to enable usb_otg_id detection,
+	 * otherwise it is the ACA detection enabled.
+	 */
+	clrbits_le32(phy_cfg2, USBNC_PHYCFG2_ACAENB);
 }
 
 int usb_phy_mode(int port)
-- 
2.6.2