[U-Boot] [RFC PATCH 12/12] mx6memcal: add configuration mx6memcal_warpboard_defconfig

[Eric Nelson]

Signed-off-by: Eric Nelson <eric at nelint.com>
---
Note that I haven't tested this board because I don't currently have one.

 configs/mx6memcal_warpboard_defconfig | 32 ++++++++++++++++++++++++++++++++
 1 file changed, 32 insertions(+)
 create mode 100644 configs/mx6memcal_warpboard_defconfig

diff --git a/configs/mx6memcal_warpboard_defconfig b/configs/mx6memcal_warpboard_defconfig
new file mode 100644
index 0000000..0ec1b3c
--- /dev/null
+++ b/configs/mx6memcal_warpboard_defconfig
@@ -0,0 +1,32 @@
+CONFIG_ARM=y
+CONFIG_ARCH_MX6=y
+CONFIG_MX6_DDRCAL=y
+CONFIG_TARGET_MX6MEMCAL=y
+CONFIG_DDRWIDTH=32
+CONFIG_DDRCS=1
+CONFIG_LPDDR2=y
+CONFIG_MT29PZZZ4D4BKESK=y
+CONFIG_DRAM_DRIVE_STRENGTH=4
+CONFIG_RALAT=2
+CONFIG_UART1_UART1=y
+CONFIG_SPL=y
+CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=arch/arm/imx-common/spl_sd.cfg,SPL,MX6SL"
+# CONFIG_CMD_BOOTD is not set
+# CONFIG_CMD_BOOTM is not set
+# CONFIG_CMD_ELF is not set
+# CONFIG_CMD_GO is not set
+# CONFIG_CMD_RUN is not set
+# CONFIG_CMD_IMI is not set
+# CONFIG_CMD_IMLS is not set
+# CONFIG_CMD_XIMG is not set
+# CONFIG_CMD_EXPORTENV is not set
+# CONFIG_CMD_IMPORTENV is not set
+# CONFIG_CMD_EDITENV is not set
+# CONFIG_CMD_SAVEENV is not set
+# CONFIG_CMD_ENV_EXISTS is not set
+# CONFIG_CMD_LOADB is not set
+# CONFIG_CMD_LOADS is not set
+# CONFIG_CMD_FLASH is not set
+# CONFIG_CMD_FPGA is not set
+# CONFIG_CMD_NET is not set
+# CONFIG_CMD_NFS is not set
-- 
2.7.4