[U-Boot] error: sdhci_send_command: Timeout for status update!

[Stefan Roese]

Steve,

On 24.06.2016 00:06, Steve Rae wrote:
> I am asking you about this code, because of this:
>    commit 29905a4 - mmc: sdhci: Use timer based timeout detection in
> sdhci_send_command()
>
> Occasionally, I am seeing failures when writing to flash on my device:
>
>    Flashing sparse image at offset 2078720
>    Flashing Sparse Image
>    sdhci_send_command: Timeout for status update!
>    mmc fail to send stop cmd
>    write_sparse_image: Write failed, block #2181088 [0]
>
> I can eliminate this error if I kludge the following code:
>
> diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c
> index 5c71ab8..854f7ce 100644
> --- a/drivers/mmc/sdhci.c
> +++ b/drivers/mmc/sdhci.c
> @@ -243,9 +243,9 @@ static int sdhci_send_command(struct mmc *mmc,
> struct mmc_cmd *cmd,
>                  if (stat & SDHCI_INT_ERROR)
>                          break;
>          } while (((stat & mask) != mask) &&
> -                (get_timer(start) < CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT));
> +                (get_timer(start) < 600 /*CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT*/));
>
> -       if (get_timer(start) >= CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT) {
> +       if (get_timer(start) >= 600 /*CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT*/) {
>                  if (host->quirks & SDHCI_QUIRK_BROKEN_R1B)
>                          return 0;
>                  else {
>
> I don't know much about this - I arrived at 600 by trial and error
> (500 fails...)
> Any ideas?

Perhaps your platform needs a bigger timeout value. Did you check
what the Linux driver does here? You could move
CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT to Kconfig with a default of 100
and select a higher value for your platform.

Thanks,
Stefan