[U-Boot] [PATCH 4/7] usb: Wait after sending Set Configuration request
Marek Vasut
marex at denx.de
Wed May 4 12:21:38 CEST 2016
On 05/04/2016 09:41 AM, Stefan Roese wrote:
> On 03.05.2016 22:51, Marek Vasut wrote:
>> Some devices, like the SanDisk Cruzer Pop need some time to process
>> the Set Configuration request, so wait a little until they are ready.
>>
>> Signed-off-by: Marek Vasut <marex at denx.de>
>> Cc: Chin Liang See <clsee at altera.com>
>> Cc: Dinh Nguyen <dinguyen at opensource.altera.com>
>> Cc: Hans de Goede <hdegoede at redhat.com>
>> Cc: Stefan Roese <sr at denx.de>
>> Cc: Stephen Warren <swarren at nvidia.com>
>> ---
>> common/usb.c | 8 ++++++++
>> 1 file changed, 8 insertions(+)
>>
>> diff --git a/common/usb.c b/common/usb.c
>> index 63429d4..205041b 100644
>> --- a/common/usb.c
>> +++ b/common/usb.c
>> @@ -1107,6 +1107,14 @@ int usb_select_config(struct usb_device *dev)
>> "len %d, status %lX\n", dev->act_len, dev->status);
>> return err;
>> }
>> +
>> + /*
>> + * Wait until the Set Configuration request gets processed by the
>> + * device. This is required by at least SanDisk Cruzer Pop USB 2.0
>> + * and Kingston DT Ultimate 32GB USB 3.0 on DWC2 OTG controller.
>> + */
>> + mdelay(10);
>> +
>> debug("new device strings: Mfr=%d, Product=%d, SerialNumber=%d\n",
>> dev->descriptor.iManufacturer, dev->descriptor.iProduct,
>> dev->descriptor.iSerialNumber);
>>
>
> As you might have expected, I'm not a fan of adding new delays to
> the common USB code. As this negatively affects all platforms. Did
> you test these two sticks that require this delay on other platforms
> than SoCFPGA?
Yes, on intel. Many microframes pass between these control EP requests,
while on the dwc2 in u-boot, quite a few of these requests end in the
same microframe because the code is fast, which is what the stick does
not like.
> I would be very interested to know, if these keys are
> successfully detected without this patch on other platforms. I
> don't have access to these USB keys, so I can't test it on my
> platforms.
>
> Thanks,
> Stefan
--
Best regards,
Marek Vasut
More information about the U-Boot
mailing list