[U-Boot] [PATCH v2 05/11] drivers: usb: musb: adopt musb backend driver to driver model
Mugunthan V N
mugunthanvnm at ti.com
Tue May 10 13:48:10 CEST 2016
Currently all backend driver ops uses hard coded physical
address, so to adopt the driver to DM, add device pointer to ops
call backs so that drivers can get physical addresses from the
usb driver priv/plat data.
Signed-off-by: Mugunthan V N <mugunthanvnm at ti.com>
---
arch/arm/cpu/armv7/am33xx/board.c | 4 ++--
arch/arm/cpu/armv7/omap3/am35x_musb.c | 6 +++---
arch/arm/include/asm/arch-omap3/musb.h | 6 +++---
arch/arm/include/asm/omap_musb.h | 7 ++++---
drivers/usb/musb-new/am35x.c | 14 +++++++-------
drivers/usb/musb-new/musb_dsps.c | 8 ++++----
6 files changed, 23 insertions(+), 22 deletions(-)
diff --git a/arch/arm/cpu/armv7/am33xx/board.c b/arch/arm/cpu/armv7/am33xx/board.c
index 8f0ff09..b8d8a3b 100644
--- a/arch/arm/cpu/armv7/am33xx/board.c
+++ b/arch/arm/cpu/armv7/am33xx/board.c
@@ -148,7 +148,7 @@ static struct musb_hdrc_config musb_config = {
};
#ifdef CONFIG_AM335X_USB0
-static void am33xx_otg0_set_phy_power(u8 on)
+static void am33xx_otg0_set_phy_power(struct udevice *dev, u8 on)
{
am33xx_usb_set_phy_power(on, &cdev->usb_ctrl0);
}
@@ -167,7 +167,7 @@ static struct musb_hdrc_platform_data otg0_plat = {
#endif
#ifdef CONFIG_AM335X_USB1
-static void am33xx_otg1_set_phy_power(u8 on)
+static void am33xx_otg1_set_phy_power(struct udevice *dev, u8 on)
{
am33xx_usb_set_phy_power(on, &cdev->usb_ctrl1);
}
diff --git a/arch/arm/cpu/armv7/omap3/am35x_musb.c b/arch/arm/cpu/armv7/omap3/am35x_musb.c
index 74dd105..d542699 100644
--- a/arch/arm/cpu/armv7/omap3/am35x_musb.c
+++ b/arch/arm/cpu/armv7/omap3/am35x_musb.c
@@ -13,7 +13,7 @@
#include <asm/io.h>
#include <asm/arch/am35x_def.h>
-void am35x_musb_reset(void)
+void am35x_musb_reset(struct udevice *dev)
{
/* Reset the musb interface */
clrsetbits_le32(&am35x_scm_general_regs->ip_sw_reset,
@@ -22,7 +22,7 @@ void am35x_musb_reset(void)
USBOTGSS_SW_RST, 0);
}
-void am35x_musb_phy_power(u8 on)
+void am35x_musb_phy_power(struct udevice *dev, u8 on)
{
unsigned long start = get_timer(0);
@@ -53,7 +53,7 @@ void am35x_musb_phy_power(u8 on)
}
}
-void am35x_musb_clear_irq(void)
+void am35x_musb_clear_irq(struct udevice *dev)
{
clrsetbits_le32(&am35x_scm_general_regs->lvl_intr_clr,
0, USBOTGSS_INT_CLR);
diff --git a/arch/arm/include/asm/arch-omap3/musb.h b/arch/arm/include/asm/arch-omap3/musb.h
index cee4ed3..d06a758 100644
--- a/arch/arm/include/asm/arch-omap3/musb.h
+++ b/arch/arm/include/asm/arch-omap3/musb.h
@@ -7,7 +7,7 @@
#ifndef __ASM_ARCH_OMAP3_MUSB_H
#define __ASM_ARCH_OMAP3_MUSB_H
-extern void am35x_musb_reset(void);
-extern void am35x_musb_phy_power(u8 on);
-extern void am35x_musb_clear_irq(void);
+void am35x_musb_reset(struct udevice *dev);
+void am35x_musb_phy_power(struct udevice *dev, u8 on);
+void am35x_musb_clear_irq(struct udevice *dev);
#endif
diff --git a/arch/arm/include/asm/omap_musb.h b/arch/arm/include/asm/omap_musb.h
index 8b9cb0e..7c5fb40 100644
--- a/arch/arm/include/asm/omap_musb.h
+++ b/arch/arm/include/asm/omap_musb.h
@@ -15,9 +15,10 @@ extern const struct musb_platform_ops omap2430_ops;
struct omap_musb_board_data {
u8 interface_type;
- void (*set_phy_power)(u8 on);
- void (*clear_irq)(void);
- void (*reset)(void);
+ struct udevice *dev;
+ void (*set_phy_power)(struct udevice *dev, u8 on);
+ void (*clear_irq)(struct udevice *dev);
+ void (*reset)(struct udevice *dev);
};
enum musb_interface {MUSB_INTERFACE_ULPI, MUSB_INTERFACE_UTMI};
diff --git a/drivers/usb/musb-new/am35x.c b/drivers/usb/musb-new/am35x.c
index b8791dd..0167ea7 100644
--- a/drivers/usb/musb-new/am35x.c
+++ b/drivers/usb/musb-new/am35x.c
@@ -336,7 +336,7 @@ eoi:
if (ret == IRQ_HANDLED || epintr || usbintr) {
/* clear level interrupt */
if (data->clear_irq)
- data->clear_irq();
+ data->clear_irq(data->dev);
/* write EOI */
musb_writel(reg_base, USB_END_OF_INTR_REG, 0);
}
@@ -401,14 +401,14 @@ static int am35x_musb_init(struct musb *musb)
/* Reset the musb */
if (data->reset)
- data->reset();
+ data->reset(data->dev);
/* Reset the controller */
musb_writel(reg_base, USB_CTRL_REG, AM35X_SOFT_RESET_MASK);
/* Start the on-chip PHY and its PLL. */
if (data->set_phy_power)
- data->set_phy_power(1);
+ data->set_phy_power(data->dev, 1);
msleep(5);
@@ -416,7 +416,7 @@ static int am35x_musb_init(struct musb *musb)
/* clear level interrupt */
if (data->clear_irq)
- data->clear_irq();
+ data->clear_irq(data->dev);
return 0;
}
@@ -439,7 +439,7 @@ static int am35x_musb_exit(struct musb *musb)
/* Shutdown the on-chip PHY and its PLL. */
if (data->set_phy_power)
- data->set_phy_power(0);
+ data->set_phy_power(data->dev, 0);
#ifndef __UBOOT__
usb_put_phy(musb->xceiv);
@@ -630,7 +630,7 @@ static int am35x_suspend(struct device *dev)
/* Shutdown the on-chip PHY and its PLL. */
if (data->set_phy_power)
- data->set_phy_power(0);
+ data->set_phy_power(data->dev, 0);
clk_disable(glue->phy_clk);
clk_disable(glue->clk);
@@ -647,7 +647,7 @@ static int am35x_resume(struct device *dev)
/* Start the on-chip PHY and its PLL. */
if (data->set_phy_power)
- data->set_phy_power(1);
+ data->set_phy_power(data->dev, 1);
ret = clk_enable(glue->phy_clk);
if (ret) {
diff --git a/drivers/usb/musb-new/musb_dsps.c b/drivers/usb/musb-new/musb_dsps.c
index bb7c952..b7f3550 100644
--- a/drivers/usb/musb-new/musb_dsps.c
+++ b/drivers/usb/musb-new/musb_dsps.c
@@ -452,7 +452,7 @@ static int dsps_musb_init(struct musb *musb)
/* Start the on-chip PHY and its PLL. */
if (data->set_phy_power)
- data->set_phy_power(1);
+ data->set_phy_power(data->dev, 1);
musb->isr = dsps_interrupt;
@@ -493,7 +493,7 @@ static int dsps_musb_exit(struct musb *musb)
/* Shutdown the on-chip PHY and its PLL. */
if (data->set_phy_power)
- data->set_phy_power(0);
+ data->set_phy_power(data->dev, 0);
#ifndef __UBOOT__
/* NOP driver needs change if supporting dual instance */
@@ -693,7 +693,7 @@ static int dsps_suspend(struct device *dev)
/* Shutdown the on-chip PHY and its PLL. */
if (data->set_phy_power)
- data->set_phy_power(0);
+ data->set_phy_power(data->dev, 0);
return 0;
}
@@ -705,7 +705,7 @@ static int dsps_resume(struct device *dev)
/* Start the on-chip PHY and its PLL. */
if (data->set_phy_power)
- data->set_phy_power(1);
+ data->set_phy_power(data->dev, 1);
return 0;
}
--
2.8.2.372.g63a3502
More information about the U-Boot
mailing list