[U-Boot] [PATCH] spl: Allow settings malloc_f base address

[Marek Vasut]

On 05/25/2016 05:30 AM, Simon Glass wrote:
> Hi Marek,

Hi!

> On 24 May 2016 at 18:14, Marek Vasut <marex at denx.de> wrote:
>> Allow configuring the begining of the malloc_f area in SPL.
>> This patch uses the same CONFIG_MALLOC_F_ADDR established by
>> the sandbox.
> 
> What is this used for? Is the existing scheme (using the stack space)
> not suitable? I think it should move to Kconfig before being used more
> widely.

In case your stack is waaay too constrained, then this is not suitable,
yep :(

>>
>> Signed-off-by: Marek Vasut <marex at denx.de>
>> Cc: Tom Rini <trini at konsulko.com>
>> Cc: Simon Glass <sjg at chromium.org>
>> ---
>>  common/spl/spl.c | 3 +++
>>  1 file changed, 3 insertions(+)
>>
>> diff --git a/common/spl/spl.c b/common/spl/spl.c
>> index 93f9bd1..56c64d1 100644
>> --- a/common/spl/spl.c
>> +++ b/common/spl/spl.c
>> @@ -160,6 +160,9 @@ int spl_init(void)
>>
>>         debug("spl_init()\n");
>>  #if defined(CONFIG_SYS_MALLOC_F_LEN)
>> +#ifdef CONFIG_MALLOC_F_ADDR
>> +       gd->malloc_base = CONFIG_MALLOC_F_ADDR;
>> +#endif
>>         gd->malloc_limit = CONFIG_SYS_MALLOC_F_LEN;
>>         gd->malloc_ptr = 0;
>>  #endif
>> --
>> 2.7.0
>>
> 
> Regards,
> Simon
> 


-- 
Best regards,
Marek Vasut