[U-Boot] [PATCH v2 1/3] spi: spi_flash: Dont set quad enable for micron in all cases

[Siva Durga Prasad Paladugu]

Dont set quad enable for micron devices in all cases
Setting the quad enable bit in micron expects all other
commands like register reads on quad lines which may
not be supported by some controllers. Hence, dont
set the quad enable if controller driver sets the
no_all_quad.

Signed-off-by: Siva Durga Prasad Paladugu <sivadur at xilinx.com>
---
Changes for v2:
- Newly added in series.
---
 drivers/mtd/spi/spi_flash.c |   13 ++++++++++++-
 include/spi.h               |    2 +-
 2 files changed, 13 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/spi/spi_flash.c b/drivers/mtd/spi/spi_flash.c
index 5451725..5b22ae2 100644
--- a/drivers/mtd/spi/spi_flash.c
+++ b/drivers/mtd/spi/spi_flash.c
@@ -926,6 +926,8 @@ static int micron_quad_enable(struct spi_flash *flash)
 
 static int set_quad_mode(struct spi_flash *flash, u8 idcode0)
 {
+	struct spi_slave *spi = flash->spi;
+
 	switch (idcode0) {
 #ifdef CONFIG_SPI_FLASH_MACRONIX
 	case SPI_FLASH_CFI_MFR_MACRONIX:
@@ -938,7 +940,16 @@ static int set_quad_mode(struct spi_flash *flash, u8 idcode0)
 #endif
 #ifdef CONFIG_SPI_FLASH_STMICRO
 	case SPI_FLASH_CFI_MFR_STMICRO:
-		return micron_quad_enable(flash);
+		/*
+		 * Set quad enable for micron only
+		 * if controller supports sending of
+		 * all commands on quad lines, otherwise
+		 * dont enable it
+		 */
+		if (spi->no_all_quad)
+			return 0;
+		else
+			return micron_quad_enable(flash);
 #endif
 	default:
 		printf("SF: Need set QEB func for %02x flash\n", idcode0);
diff --git a/include/spi.h b/include/spi.h
index 4b88d39..17c6e4d 100644
--- a/include/spi.h
+++ b/include/spi.h
@@ -117,7 +117,7 @@ struct spi_slave {
 	unsigned int max_write_size;
 	void *memory_map;
 	u8 option;
-
+	u8 no_all_quad;
 	u8 flags;
 #define SPI_XFER_BEGIN		BIT(0)	/* Assert CS before transfer */
 #define SPI_XFER_END		BIT(1)	/* Deassert CS after transfer */
-- 
1.7.1