[U-Boot] [PATCH v2 8/9] cmd: fdt: add fdt overlay application subcommand

[Maxime Ripard]

The device tree overlays are a good way to deal with user-modifyable
boards or boards with some kind of an expansion mechanism where we can
easily plug new board in (like the BBB or the raspberry pi).

However, so far, the usual mechanism to deal with it was to have in Linux
some driver detecting the expansion boards plugged in and then request
these overlays using the firmware interface.

That works in most cases, but in some cases, you might want to have the
overlays applied before the userspace comes in. Either because the new
board requires some kind of an early initialization, or because your root
filesystem is accessed through that expansion board.

The easiest solution in such a case is to simply have the component before
Linux applying that overlay, removing all these drawbacks.

Signed-off-by: Maxime Ripard <maxime.ripard at free-electrons.com>
---
 cmd/fdt.c | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/cmd/fdt.c b/cmd/fdt.c
index 0f5923e75a41..6cbc9e525d6c 100644
--- a/cmd/fdt.c
+++ b/cmd/fdt.c
@@ -639,6 +639,25 @@ static int do_fdt(cmd_tbl_t *cmdtp, int flag, int argc, char * const argv[])
 #endif
 
 	}
+	/* apply an overlay */
+	else if (strncmp(argv[1], "ap", 2) == 0) {
+		unsigned long addr;
+		struct fdt_header *blob;
+
+		if (argc != 3)
+			return CMD_RET_USAGE;
+
+		if (!working_fdt)
+			return CMD_RET_FAILURE;
+
+		addr = simple_strtoul(argv[2], NULL, 16);
+		blob = map_sysmem(addr, 0);
+		if (!fdt_valid(&blob))
+			return CMD_RET_FAILURE;
+
+		if (fdt_overlay_apply(working_fdt, blob))
+			return CMD_RET_FAILURE;
+	}
 	/* resize the fdt */
 	else if (strncmp(argv[1], "re", 2) == 0) {
 		fdt_shrink_to_minimum(working_fdt);
@@ -1025,6 +1044,7 @@ static int fdt_print(const char *pathp, char *prop, int depth)
 #ifdef CONFIG_SYS_LONGHELP
 static char fdt_help_text[] =
 	"addr [-c]  <addr> [<length>]   - Set the [control] fdt location to <addr>\n"
+	"fdt apply <addr>                    - Apply overlay to the DT\n"
 #ifdef CONFIG_OF_BOARD_SETUP
 	"fdt boardsetup                      - Do board-specific set up\n"
 #endif
-- 
2.8.2