[U-Boot] [PATCH v3 00/10] mx7: add dt support for Colibri iMX7S/iMX7D

[Stefano Babic]

On 06/10/2016 00:27, Stefan Agner wrote:
> From: Stefan Agner <stefan.agner at toradex.com>
> 
> This patchset adds device tree support for Colibri iMX7S/iMX7D.
> It is the first device tree enabled board for any i.MX 7 SoC
> hence the patchset adds some common infrastructure:
> - Add device tree support for serial_mxc.
> - imx7.dtsi - I descided to leave the s/d suffix since the SoCs
>   are very similar and boards will likely use runtime detection
>   to distinguish the two available SoCs.
> - The pinmux file imx7d-pinfunc.h is taken from the Kernel and
>   stored in the same place
> 
> Otherwise the conversion is quite straightforward and simplified
> the board code somewhat. Two patches enhance the board support
> with PMIC support, which has been the driver for this conversion.
> 
> Changes since v2:
> - Drop CONFIG_CUSTOM_BOARDINFO again
> - Add ifdef OF_CONTROL in serial-mxc driver to allow building the
>   driver without OF support
> 

Thanks - I merge the whole series and push to -master.

Regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================