[U-Boot] [PATCH v3 05/12] arm: socfpga: fpgamgr: Disable FPGA Manager for Stratix 10

[Chin Liang See]

On Sen, 2016-10-17 at 17:20 +0200, Marek Vasut wrote:
> On 10/17/2016 05:14 PM, Chin Liang See wrote:
> > 
> > On Sen, 2016-10-17 at 15:42 +0200, Marek Vasut wrote:
> > > 
> > > On 10/17/2016 03:35 PM, See, Chin Liang wrote:
> > > > 
> > > > 
> > > > On Min, 2016-10-16 at 17:34 +0200, Marek Vasut wrote:
> > > > > 
> > > > > 
> > > > > On 10/13/2016 10:33 AM, Chin Liang See wrote:
> > > > > > 
> > > > > > 
> > > > > > 
> > > > > > Disable the FPGA Manager for Stratix 10 SoC as we are not
> > > > > > using this for SOCVP
> > > > > If it's not used on SoCVP, then shouldn't this be disabled
> > > > > only
> > > > > for
> > > > > SoCVP instead of S10 ?
> > > > > 
> > > > We will be enhancing this code to support the hardware /
> > > > emulation
> > > > in
> > > > later phase. In another word, will switch the support from
> > > > SOCVP to
> > > > hardware once its available.
> > > > 
> > > This is confusing, what would happen if someone tries to use old
> > > u-
> > > boot
> > > on real hardware ?
> > It won't work until added drivers for Clocks, Reset and DDR.
> > Current
> > state would be good for SOCVP only where not all hardware is
> > simulated.
> In that case, mark it as SoCVP to prevent confusion please.
> 

In this case, I can update the config to indicate this is S10 SOCVP.

Thanks
Chin Liang

> 
> --
> Best regards,
> Marek Vasut
> 
> ________________________________
> 
> Confidentiality Notice.
> This message may contain information that is confidential or
> otherwise protected from disclosure. If you are not the intended
> recipient, you are hereby notified that any use, disclosure,
> dissemination, distribution, or copying of this message, or any
> attachments, is strictly prohibited. If you have received this
> message in error, please advise the sender by reply e-mail, and
> delete the message and any attachments. Thank you.