[U-Boot] [PATCH] armv8/ls1043a: Add the OCRAM initialization

[york sun]

On 10/16/2016 10:35 PM, Prabhakar Kushwaha wrote:
> Hi Mingkai,
>
>> -----Original Message-----
>> From: Pratiyush Srivastava [mailto:pratiyush.srivastava at nxp.com]
>> Sent: Wednesday, October 12, 2016 5:46 PM
>> To: u-boot at lists.denx.de
>> Cc: york sun <york.sun at nxp.com>; Prabhakar Kushwaha
>> <prabhakar.kushwaha at nxp.com>; Pratiyush Srivastava
>> <pratiyush.srivastava at nxp.com>; Hou Zhiqiang <Zhiqiang.Hou at freescale.com>
>> Subject: [PATCH] armv8/ls1043a: Add the OCRAM initialization
>>
>> Clear the content to zero and the ECC error bit of OCRAM1/2.
>>
>> The OCRAM must be initialized to ZERO by the unit of 8-Byte before
>> accessing it, or else it will generate ECC error. And the IBR has
>> accessed the OCRAM before this initialization, so the ECC error
>> status bit should to be cleared.
>>
>> Signed-off-by: Pratiyush Srivastava <pratiyush.srivastava at nxp.com>
>> Signed-off-by: Hou Zhiqiang <Zhiqiang.Hou at freescale.com>
>> Signed-off-by: Prabhakar Kushwaha <prabhakar.kushwaha at nxp.com>
>> ---
>
> This requirement is for both ls1043 and ls1088a.  was this patch taken care during ls1043a upstreaming
> If not, how it is being taken care for ls1043a.  Same approach can be used for ls1088a
>

I wonder why we don't see ECC errors before this patch. We have LS1043A 
boots on NAND, SD.

York