[U-Boot] [RFC PATCH v2 08/10] mtd: pxa3xx_nand: Fix initial controller configuration

[Chris Packham]

The Data Flash Control Register (NDCR) contains two types
of parameters: those that are needed for device identification,
and those that can only be set after device identification.

Therefore, the driver can't set them all at once and instead
needs to configure the first group before nand_scan_ident()
and the second group later.

Let's split pxa3xx_nand_config in two halves, and set the
parameters that depend on the device geometry once this is known.

[ Linux commit 66e8e47eae658dc884e65695a597fdda7a109448 ]

Cc: Ezequiel Garcia <ezequiel at vanguardiasur.com.ar>
Signed-off-by: Chris Packham <judge.packham at gmail.com>
---

Changes in v2:
- New

 drivers/mtd/nand/pxa3xx_nand.c | 41 +++++++++++++++++++++++++++++------------
 1 file changed, 29 insertions(+), 12 deletions(-)

diff --git a/drivers/mtd/nand/pxa3xx_nand.c b/drivers/mtd/nand/pxa3xx_nand.c
index 146ef096ea3f..432219c78831 100644
--- a/drivers/mtd/nand/pxa3xx_nand.c
+++ b/drivers/mtd/nand/pxa3xx_nand.c
@@ -59,7 +59,8 @@
 #define NDCR_ND_MODE		(0x3 << 21)
 #define NDCR_NAND_MODE		(0x0)
 #define NDCR_CLR_PG_CNT		(0x1 << 20)
-#define NDCR_STOP_ON_UNCOR	(0x1 << 19)
+#define NFCV1_NDCR_ARB_CNTL	(0x1 << 19)
+#define NFCV2_NDCR_STOP_ON_UNCOR	(0x1 << 19)
 #define NDCR_RD_ID_CNT_MASK	(0x7 << 16)
 #define NDCR_RD_ID_CNT(x)	(((x) << 16) & NDCR_RD_ID_CNT_MASK)
 
@@ -1226,26 +1227,41 @@ static int pxa3xx_nand_waitfunc(struct mtd_info *mtd, struct nand_chip *this)
 	return NAND_STATUS_READY;
 }
 
-static int pxa3xx_nand_config_flash(struct pxa3xx_nand_info *info)
+static int pxa3xx_nand_config_ident(struct pxa3xx_nand_info *info)
+{
+	struct pxa3xx_nand_platform_data *pdata = info->pdata;
+
+	/* Configure default flash values */
+	info->chunk_size = PAGE_CHUNK_SIZE;
+	info->reg_ndcr = 0x0; /* enable all interrupts */
+	info->reg_ndcr |= (pdata->enable_arbiter) ? NDCR_ND_ARB_EN : 0;
+	info->reg_ndcr |= NDCR_RD_ID_CNT(READ_ID_BYTES);
+	info->reg_ndcr |= NDCR_SPARE_EN;
+
+	return 0;
+}
+
+static void pxa3xx_nand_config_tail(struct pxa3xx_nand_info *info)
 {
 	struct pxa3xx_nand_host *host = info->host[info->cs];
-	struct mtd_info *mtd = nand_to_mtd(&host->chip);
+	struct mtd_info *mtd = nand_to_mtd(&info->host[info->cs]->chip);
 	struct nand_chip *chip = mtd_to_nand(mtd);
 
 	info->reg_ndcr |= (host->col_addr_cycles == 2) ? NDCR_RA_START : 0;
 	info->reg_ndcr |= (chip->page_shift == 6) ? NDCR_PG_PER_BLK : 0;
 	info->reg_ndcr |= (mtd->writesize == 2048) ? NDCR_PAGE_SZ : 0;
-
-	return 0;
 }
 
 static int pxa3xx_nand_detect_config(struct pxa3xx_nand_info *info)
 {
+	struct pxa3xx_nand_platform_data *pdata = info->pdata;
 	uint32_t ndcr = nand_readl(info, NDCR);
 
 	/* Set an initial chunk size */
 	info->chunk_size = ndcr & NDCR_PAGE_SZ ? 2048 : 512;
-	info->reg_ndcr = ndcr & ~NDCR_INT_MASK;
+	info->reg_ndcr = ndcr &
+		~(NDCR_INT_MASK | NDCR_ND_ARB_EN | NFCV1_NDCR_ARB_CNTL);
+	info->reg_ndcr |= (pdata->enable_arbiter) ? NDCR_ND_ARB_EN : 0;
 	info->ndtr0cs0 = nand_readl(info, NDTR0CS0);
 	info->ndtr1cs0 = nand_readl(info, NDTR1CS0);
 	return 0;
@@ -1371,8 +1387,9 @@ static int pxa3xx_nand_scan(struct mtd_info *mtd)
 	if (pdata->keep_config && !pxa3xx_nand_detect_config(info))
 		goto KEEP_CONFIG;
 
-	/* Set a default chunk size */
-	info->chunk_size = PAGE_CHUNK_SIZE;
+	ret = pxa3xx_nand_config_ident(info);
+	if (ret)
+		return ret;
 
 	ret = pxa3xx_nand_sensing(host);
 	if (ret) {
@@ -1399,10 +1416,6 @@ KEEP_CONFIG:
 		}
 	}
 
-	ret = pxa3xx_nand_config_flash(info);
-	if (ret)
-		return ret;
-
 #ifdef CONFIG_SYS_NAND_USE_FLASH_BBT
 	/*
 	 * We'll use a bad block table stored in-flash and don't
@@ -1467,6 +1480,10 @@ KEEP_CONFIG:
 		host->row_addr_cycles = 3;
 	else
 		host->row_addr_cycles = 2;
+
+	if (!pdata->keep_config)
+		pxa3xx_nand_config_tail(info);
+
 	return nand_scan_tail(mtd);
 }
 
-- 
2.10.1