[U-Boot] [PATCH] ARM: DT: STM32F746: add u-boot, dm-pre-reloc property to sub nodes

[Vikas Manocha]

This patch is required for correct SPL device tree creation by fdtgrep
as fdtgrep looks for u-boot,dm-pre-reloc property of the node to include
it in the spl device tree.

Not adding it in these subnodes ignores the pin muxing of peripherals
which is almost always in the subnodes.

Signed-off-by: Vikas Manocha <vikas.manocha at st.com>
---
 arch/arm/dts/stm32f746-disco.dts | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/arch/arm/dts/stm32f746-disco.dts b/arch/arm/dts/stm32f746-disco.dts
index 2c7fa79..30c92ef 100644
--- a/arch/arm/dts/stm32f746-disco.dts
+++ b/arch/arm/dts/stm32f746-disco.dts
@@ -96,15 +96,18 @@
 
 &pinctrl {
 	usart1_pins_a: usart1 at 0	{
+		u-boot,dm-pre-reloc;
 		pins1 {
-		       pinmux = <STM32F746_PA9_FUNC_USART1_TX>;
+			pinmux = <STM32F746_PA9_FUNC_USART1_TX>;
 				bias-disable;
 				drive-push-pull;
 				slew-rate = <2>;
+			u-boot,dm-pre-reloc;
 		};
 		pins2 {
 			pinmux = <STM32F746_PB7_FUNC_USART1_RX>;
 			bias-disable;
+			u-boot,dm-pre-reloc;
 		};
 	};
 
@@ -136,7 +139,9 @@
 	};
 
 	fmc_pins: fmc at 0 {
+			u-boot,dm-pre-reloc;
 		pins {
+			u-boot,dm-pre-reloc;
 			pinmux = <STM32F746_PD10_FUNC_FMC_D15>,
 				 <STM32F746_PD9_FUNC_FMC_D14>,
 				 <STM32F746_PD8_FUNC_FMC_D13>,
@@ -198,6 +203,7 @@
 	mr-nbanks = <1>;
 	/* Memory configuration from sdram datasheet MT48LC_4M32_B2B5-6A */
 	bank1: bank at 0 {
+	       u-boot,dm-pre-reloc;
 	       st,sdram-control = /bits/ 8 <NO_COL_8 NO_ROW_12 MWIDTH_16 BANKS_4
 	       				    CAS_3 SDCLK_2 RD_BURST_EN
 					    RD_PIPE_DL_0>;
-- 
1.9.1