[U-Boot] [PATCH v3 1/2] mx6sabresd: Make SPL DDR configuration to match the DCD table

[Jagan Teki]

On Wed, Apr 5, 2017 at 5:29 AM, Fabio Estevam <festevam at gmail.com> wrote:
> Hi Jagan,
>
> On Tue, Apr 4, 2017 at 2:27 PM, Jagan Teki <jagannadh.teki at gmail.com> wrote:
>
>> No, this isn't issue, just want to understand how you create reg init
>> in SPL in mx6q_dcd_table, means did you follow any order. because I'm
>> planning move *dl.cfg DCD to SPL
>
> Ok, got it. I thought you were asking about mx6qp sabreauto not booting.
>
> On this patch I just did a 1:1 translation from DCD to SPL code.

I saw the reg with respective values same from *.cfg but the sequence
of registers are not direct compared to DCD from *.cfg? am I correct?

thanks!
-- 
Jagan Teki
Free Software Engineer | www.openedev.com
U-Boot, Linux | Upstream Maintainer
Hyderabad, India.