[U-Boot] [PATCH v2 07/29] ARM: i.MX6QP: sabresd: Add initial devicetree support

[Jagan Teki]

On Thu, Apr 6, 2017 at 7:29 AM, Peng Fan <van.freenix at gmail.com> wrote:
> On Mon, Apr 03, 2017 at 07:23:14PM +0530, Jagan Teki wrote:
>>From: Jagan Teki <jagan at amarulasolutions.com>
>>
>>Add initial dts support for i.MX6 Quad Plus Sabresd board.
>>
>>Boot from MMC:
>>-------------
>>U-Boot SPL 2017.03-33690-ga80e4f6-dirty (Mar 30 2017 - 00:40:29)
>>Trying to boot from MMC1
>>
>>U-Boot 2017.03-33690-ga80e4f6-dirty (Mar 30 2017 - 00:40:29 +0530)
>>
>>CPU:   Freescale i.MX6QP rev1.0 996 MHz (running at 792 MHz)
>>CPU:   Automotive temperature grade (-40C to 125C) at 29C
>>Reset cause: POR
>>Model: Freescale i.MX6 Quad Plus SABRE Smart Device Board
>>Board: MX6-SabreSD
>>I2C:   ready
>>DRAM:  1 GiB
>>PMIC:  PFUZE100 ID=0x10
>>MMC:   FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2
>>*** Warning - bad CRC, using default environment
>>
>>gpio at 020a4000: dir_output: error: gpio GPIO3_19 not reserved
>>gpio at 020a4000: set_value: error: gpio GPIO3_19 not reserved
>>gpio at 020b4000: dir_output: error: gpio GPIO7_12 not reserved
>>gpio at 020b4000: set_value: error: gpio GPIO7_12 not reserved
>>PCI:   pcie phy link never came up
>>No panel detected: default to Hannstar-XGA
>>gpio at 0209c000: dir_output: error: gpio GPIO1_21 not reserved
>>Display: Hannstar-XGA (1024x768)
>>In:    serial
>>Out:   serial
>>Err:   serial
>>Net:   gpio at 0209c000: dir_output: error: gpio GPIO1_25 not reserved
>>gpio at 0209c000: set_value: error: gpio GPIO1_25 not reserved
>>FEC [PRIME]
>>Hit any key to stop autoboot:  0
>>=>
>>
>>Cc: Stefano Babic <sbabic at denx.de>
>>Cc: Fabio Estevam <fabio.estevam at nxp.com>
>>Cc: Michael Trimarchi <michael at amarulasolutions.com>
>>Signed-off-by: Jagan Teki <jagan at amarulasolutions.com>
>>---
>> board/freescale/mx6sabresd/MAINTAINERS |  1 +
>> configs/imx6qp_sabresd_defconfig       | 60 ++++++++++++++++++++++++++++++++++
>
> Could this be renamed to imx6qp_sabresd_spl_defconfig?

See my 28/29 patch comment, We are not keeping non-spl so there is no
need to explicitly specify the name _spl

thanks!
-- 
Jagan Teki
Free Software Engineer | www.openedev.com
U-Boot, Linux | Upstream Maintainer
Hyderabad, India.