[U-Boot] [PATCH v3] spi: atmel: check GPIO validity before using cs_gpios

[Wenyou Yang]

Before using the cs_gpio, check if the GPIO is valid or not.

Signed-off-by: Wenyou Yang <wenyou.yang at atmel.com>
---

Changes in v3:
 - According to the advice from Jagan Teki, rearrange the code.

Changes in v2:
 - Rebase on v2017.03.

 drivers/spi/atmel_spi.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/drivers/spi/atmel_spi.c b/drivers/spi/atmel_spi.c
index 7649114231..4701b79f16 100644
--- a/drivers/spi/atmel_spi.c
+++ b/drivers/spi/atmel_spi.c
@@ -296,6 +296,9 @@ static void atmel_spi_cs_activate(struct udevice *dev)
 	struct dm_spi_slave_platdata *slave_plat = dev_get_parent_platdata(dev);
 	u32 cs = slave_plat->cs;
 
+	if (!dm_gpio_is_valid(&priv->cs_gpios[cs]))
+		return;
+
 	dm_gpio_set_value(&priv->cs_gpios[cs], 0);
 }
 
@@ -306,6 +309,9 @@ static void atmel_spi_cs_deactivate(struct udevice *dev)
 	struct dm_spi_slave_platdata *slave_plat = dev_get_parent_platdata(dev);
 	u32 cs = slave_plat->cs;
 
+	if (!dm_gpio_is_valid(&priv->cs_gpios[cs]))
+		return;
+
 	dm_gpio_set_value(&priv->cs_gpios[cs], 1);
 }
 
@@ -473,6 +479,9 @@ static int atmel_spi_probe(struct udevice *bus)
 	}
 
 	for(i = 0; i < ARRAY_SIZE(priv->cs_gpios); i++) {
+		if (!dm_gpio_is_valid(&priv->cs_gpios[i]))
+			continue;
+
 		dm_gpio_set_dir_flags(&priv->cs_gpios[i],
 				      GPIOD_IS_OUT | GPIOD_IS_OUT_ACTIVE);
 	}
-- 
2.11.0