[U-Boot] [PATCH v4 14/19] arm: socfpga: Add SPL support for Arria 10

[Dinh Nguyen]

On 04/05/2017 04:32 AM, Ley Foon Tan wrote:
> Add SPL support for Arria 10.
> 
> Signed-off-by: Tien Fong Chee <tien.fong.chee at intel.com>
> Signed-off-by: Ley Foon Tan <ley.foon.tan at intel.com>
> ---
>  arch/arm/mach-socfpga/spl.c | 74 ++++++++++++++++++++++++++++++++++++++++++---
>  1 file changed, 69 insertions(+), 5 deletions(-)
> 
> diff --git a/arch/arm/mach-socfpga/spl.c b/arch/arm/mach-socfpga/spl.c
> index 69c433c..e1e62c2 100644
> --- a/arch/arm/mach-socfpga/spl.c
> +++ b/arch/arm/mach-socfpga/spl.c
> @@ -19,23 +19,32 @@
>  #include <asm/arch/sdram.h>
>  #include <asm/arch/scu.h>
>  #include <asm/arch/nic301.h>
> +#include <asm/sections.h>
> +#include <fdtdec.h>
> +#include <watchdog.h>
> +#if defined(CONFIG_TARGET_SOCFPGA_ARRIA10)
> +#include <asm/arch/pinmux.h>
> +#endif
>  
>  DECLARE_GLOBAL_DATA_PTR;
>  
> +#if defined(CONFIG_TARGET_SOCFPGA_GEN5)
>  static struct pl310_regs *const pl310 =
>  	(struct pl310_regs *)CONFIG_SYS_PL310_BASE;
>  static struct scu_registers *scu_regs =
>  	(struct scu_registers *)SOCFPGA_MPUSCU_ADDRESS;
>  static struct nic301_registers *nic301_regs =
>  	(struct nic301_registers *)SOCFPGA_L3REGS_ADDRESS;
> -static struct socfpga_system_manager *sysmgr_regs =
> +#endif
> +
> +static const struct socfpga_system_manager *sysmgr_regs =
>  	(struct socfpga_system_manager *)SOCFPGA_SYSMGR_ADDRESS;
>  
>  u32 spl_boot_device(void)
>  {
>  	const u32 bsel = readl(&sysmgr_regs->bootinfo);
>  
> -	switch (bsel & 0x7) {
> +	switch (SYSMGR_GET_BOOTINFO_BSEL(bsel)) {
>  	case 0x1:	/* FPGA (HPS2FPGA Bridge) */
>  		return BOOT_DEVICE_RAM;
>  	case 0x2:	/* NAND Flash (1.8V) */
> @@ -68,6 +77,7 @@ u32 spl_boot_mode(const u32 boot_device)
>  }
>  #endif
>  
> +#if defined(CONFIG_TARGET_SOCFPGA_GEN5)
>  static void socfpga_nic301_slave_ns(void)
>  {
>  	writel(0x1, &nic301_regs->lwhps2fpgaregs);
> @@ -85,6 +95,7 @@ void board_init_f(ulong dummy)
>  #endif
>  	unsigned long sdram_size;
>  	unsigned long reg;
> +	int ret;
>  
>  	/*
>  	 * First C code to run. Clear fake OCRAM ECC first as SBE
> @@ -117,7 +128,11 @@ void board_init_f(ulong dummy)
>  	/* Put everything into reset but L4WD0. */
>  	socfpga_per_reset_all();
>  	/* Put FPGA bridges into reset too. */
> -	socfpga_bridges_reset(1);
> +	ret = socfpga_bridges_reset(1);
> +	if (ret) {
> +		printf("socfpga_bridges_reset() failed: %d\n", ret);
> +		hang();
> +	}
>  
>  	socfpga_per_reset(SOCFPGA_RESET(SDR), 0);
>  	socfpga_per_reset(SOCFPGA_RESET(UART0), 0);
> @@ -150,7 +165,11 @@ void board_init_f(ulong dummy)
>  
>  	/* De-assert reset for peripherals and bridges based on handoff */
>  	reset_deassert_peripherals_handoff();
> -	socfpga_bridges_reset(0);
> +	ret = socfpga_bridges_reset(0);
> +	if (ret) {
> +		printf("socfpga_bridges_reset() failed: %d\n", ret);
> +		hang();
> +	}
>  
>  	debug("Unfreezing/Thaw all I/O banks\n");
>  	/* unfreeze / thaw all IO banks */
> @@ -180,8 +199,53 @@ void board_init_f(ulong dummy)
>  		hang();
>  	}
>  
> -	socfpga_bridges_reset(1);
> +	ret = socfpga_bridges_reset(1);
> +	if (ret) {
> +		printf("socfpga_bridges_reset() failed: %d\n", ret);
> +		hang();
> +	}
>  
>  	/* Configure simple malloc base pointer into RAM. */
>  	gd->malloc_base = CONFIG_SYS_TEXT_BASE + (1024 * 1024);
>  }
> +#elif defined(CONFIG_TARGET_SOCFPGA_ARRIA10)
> +#ifdef CONFIG_SPL_BOARD_INIT
> +void spl_board_init(void)

Don't need to add another check for SPL_BOARD_INIT, it's already defined
for CONFIG_TARGET_SOCFPGA_ARRIA10.

Dinh