[U-Boot] [PATCH V2 12/12] imx: mx7dsabresd: add board revision check

[Peng Fan]

Add board revision check

Signed-off-by: Peng Fan <peng.fan at nxp.com>
---
 board/freescale/mx7dsabresd/mx7dsabresd.c | 59 ++++++++++++++++++++++++++++++-
 1 file changed, 58 insertions(+), 1 deletion(-)

diff --git a/board/freescale/mx7dsabresd/mx7dsabresd.c b/board/freescale/mx7dsabresd/mx7dsabresd.c
index ecea5a5..07392fa 100644
--- a/board/freescale/mx7dsabresd/mx7dsabresd.c
+++ b/board/freescale/mx7dsabresd/mx7dsabresd.c
@@ -82,6 +82,48 @@ static iomux_v3_cfg_t const uart1_pads[] = {
 	MX7D_PAD_UART1_RX_DATA__UART1_DCE_RX | MUX_PAD_CTRL(UART_PAD_CTRL),
 };
 
+#define BOARD_REV_C  0x300
+#define BOARD_REV_B  0x200
+#define BOARD_REV_A  0x100
+
+static int mx7sabre_rev(void)
+{
+	/*
+	 * Get Board ID information from OCOTP_GP1[15:8]
+	 * i.MX7D SDB RevA: 0x41
+	 * i.MX7D SDB RevB: 0x42
+	 */
+	struct ocotp_regs *ocotp = (struct ocotp_regs *)OCOTP_BASE_ADDR;
+	struct fuse_bank *bank = &ocotp->bank[14];
+	int reg = readl(&bank->fuse_regs[0]);
+	int ret;
+
+	if (reg != 0) {
+		switch (reg >> 8 & 0x0F) {
+		case 0x3:
+			ret = BOARD_REV_C;
+			break;
+		case 0x02:
+			ret = BOARD_REV_B;
+			break;
+		case 0x01:
+		default:
+			ret = BOARD_REV_A;
+			break;
+		}
+	} else {
+		/* If the gp1 fuse is not burn, we have to use TO rev for the board rev */
+		if (is_soc_rev(CHIP_REV_1_0))
+			ret = BOARD_REV_A;
+		else if (is_soc_rev(CHIP_REV_1_1))
+			ret = BOARD_REV_B;
+		else
+			ret = BOARD_REV_C;
+	}
+
+	return ret;
+}
+
 #ifdef CONFIG_NAND_MXS
 static iomux_v3_cfg_t const gpmi_pads[] = {
 	MX7D_PAD_SD3_DATA0__NAND_DATA00 | MUX_PAD_CTRL(NAND_PAD_CTRL),
@@ -377,14 +419,29 @@ int board_late_init(void)
 
 int checkboard(void)
 {
+	int rev = mx7sabre_rev();
 	char *mode;
+	char *revname;
 
 	if (IS_ENABLED(CONFIG_ARMV7_BOOT_SEC_DEFAULT))
 		mode = "secure";
 	else
 		mode = "non-secure";
 
-	printf("Board: i.MX7D SABRESD in %s mode\n", mode);
+	switch (rev) {
+	case BOARD_REV_C:
+		revname = "C";
+		break;
+	case BOARD_REV_B:
+		revname = "B";
+		break;
+	case BOARD_REV_A:
+	default:
+		revname = "A";
+		break;
+	}
+
+	printf("Board: i.MX7D SABRESD Rev%s in %s mode\n", revname, mode);
 
 	return 0;
 }
-- 
2.6.2