[U-Boot] [PATCH] mmc: zynq_sdhci: improve debug print

[Jaehoon Chung]

On 04/14/2017 03:29 PM, Jaehoon Chung wrote:
> On 04/03/2017 10:42 AM, Jean-Francois Dagenais wrote:
>> When debugging dual SDHCI controller setup, printing strings and bank info
>> is very helpful.
>>
>> Signed-off-by: Jean-Francois Dagenais <jeff.dagenais at gmail.com>
> 
> This was delegated to Michal, but it's related to mmc side.
> So i will change to delegate to me..and applied to u-boot-mmc. Thanks!

Sorry. i can't apply this patch..Could you check this?

Best Regards,
Jaehoon Chung

> 
> Best Regards,
> Jaehoon Chung
> 
>> ---
>>  drivers/mmc/zynq_sdhci.c | 4 ++--
>>  1 file changed, 2 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/mmc/zynq_sdhci.c b/drivers/mmc/zynq_sdhci.c
>> index 089a424..f975165 100644
>> --- a/drivers/mmc/zynq_sdhci.c
>> +++ b/drivers/mmc/zynq_sdhci.c
>> @@ -160,8 +160,8 @@ static void arasan_sdhci_set_tapdelay(struct sdhci_host *host)
>>  	else
>>  		return;
>>  
>> -	debug("%s, %d:%d, mode:%d\n", __func__, priv->deviceid, priv->bank,
>> -	      uhsmode);
>> +	debug("%s, host:%s devId:%d, bank:%d, mode:%d\n", __func__, host->name,
>> +	      priv->deviceid, priv->bank, uhsmode);
>>  	if ((uhsmode >= MMC_TIMING_UHS_SDR25) &&
>>  	    (uhsmode <= MMC_TIMING_HS200))
>>  		arasan_zynqmp_set_tapdelay(priv->deviceid, uhsmode,
>>
> 
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> https://lists.denx.de/listinfo/u-boot
>