[U-Boot] [RESEND PATCH v2 2/6] MIPS: Make CM GCR base configurable

[Daniel Schwierzeck]

From: Paul Burton <paul.burton at imgtec.com>

Without adding a prompt for CONFIG_MIPS_CM_BASE, Kconfig doesn't allow
defconfigs to set it. Provide the prompt in order to allow for that.

Signed-off-by: Paul Burton <paul.burton at imgtec.com>
Signed-off-by: Daniel Schwierzeck <daniel.schwierzeck at gmail.com>

---

Changes in v2:
- move to menu "General setup"

 arch/mips/Kconfig | 19 ++++++++++---------
 1 file changed, 10 insertions(+), 9 deletions(-)

diff --git a/arch/mips/Kconfig b/arch/mips/Kconfig
index c97ea4156b..77d1ac65d2 100644
--- a/arch/mips/Kconfig
+++ b/arch/mips/Kconfig
@@ -221,6 +221,16 @@ config ROM_EXCEPTION_VECTORS
 	  Disable this, if the U-Boot image is booted from DRAM (e.g. by SPL).
 	  In that case the image size will be reduced by 0x500 bytes.
 
+config MIPS_CM_BASE
+	hex "MIPS CM GCR Base Address"
+	depends on MIPS_CM
+	default 0x1fbf8000
+	help
+	  The physical base address at which to map the MIPS Coherence Manager
+	  Global Configuration Registers (GCRs). This should be set such that
+	  the GCRs occupy a region of the physical address space which is
+	  otherwise unused, or at minimum that software doesn't need to access.
+
 endmenu
 
 menu "OS boot interface"
@@ -393,15 +403,6 @@ config MIPS_CM
 	  wish U-Boot to configure it or make use of it to retrieve system
 	  information such as cache configuration.
 
-config MIPS_CM_BASE
-	hex
-	default 0x1fbf8000
-	help
-	  The physical base address at which to map the MIPS Coherence Manager
-	  Global Configuration Registers (GCRs). This should be set such that
-	  the GCRs occupy a region of the physical address space which is
-	  otherwise unused, or at minimum that software doesn't need to access.
-
 endif
 
 endmenu
-- 
2.11.0