[U-Boot] [PATCH 4/5] x86: ich-spi: Move opcode registers configuration to another routine

[Bin Meng]

On Wed, Aug 16, 2017 at 2:19 PM, Stefan Roese <sr at denx.de> wrote:
> On 16.08.2017 07:38, Bin Meng wrote:
>>
>> At present the ICH SPI opcode registers configuration is done in the
>> ich_spi_remove() routine, a little bit weird but that's how current.
>> Linux MTD driver works. This changes to move the opcode registers
>> configuration to a separate routine ich_spi_config_opcode() which
>> might be called by U-Boot itself as well.
>>
>> Signed-off-by: Bin Meng <bmeng.cn at gmail.com>
>> ---
>>
>>   drivers/spi/ich.c | 22 ++++++++++++++++------
>>   1 file changed, 16 insertions(+), 6 deletions(-)
>>
>> diff --git a/drivers/spi/ich.c b/drivers/spi/ich.c
>> index d4888f5..373bc26 100644
>> --- a/drivers/spi/ich.c
>> +++ b/drivers/spi/ich.c
>> @@ -338,6 +338,21 @@ static int ich_status_poll(struct ich_spi_priv *ctlr,
>> u16 bitmask,
>>         return -ETIMEDOUT;
>>   }
>>   +void ich_spi_config_opcode(struct udevice *dev)
>> +{
>> +       struct ich_spi_priv *ctlr = dev_get_priv(dev);
>> +
>> +       /*
>> +        * PREOP, OPTYPE, OPMENU1/OPMENU2 registers can be locked down
>> +        * to prevent accidental or intentional writes. Before they get
>> +        * locked down, these registers should be initialized properly.
>> +        */
>> +       ich_writew(ctlr, SPI_OPPREFIX, ctlr->preop);
>> +       ich_writew(ctlr, SPI_OPTYPE, ctlr->optype);
>> +       ich_writel(ctlr, SPI_OPMENU_LOWER, ctlr->opmenu);
>> +       ich_writel(ctlr, SPI_OPMENU_UPPER, ctlr->opmenu + sizeof(u32));
>> +}
>> +
>>   static int ich_spi_xfer(struct udevice *dev, unsigned int bitlen,
>>                         const void *dout, void *din, unsigned long flags)
>>   {
>> @@ -585,16 +600,11 @@ static int ich_spi_probe(struct udevice *dev)
>>     static int ich_spi_remove(struct udevice *bus)
>>   {
>> -       struct ich_spi_priv *ctlr = dev_get_priv(bus);
>> -
>>         /*
>>          * Configure SPI controller so that the Linux MTD driver can fully
>>          * access the SPI NOR chip
>>          */
>> -       ich_writew(ctlr, SPI_OPPREFIX, ctlr->preop);
>> -       ich_writew(ctlr, SPI_OPTYPE, ctlr->optype);
>> -       ich_writel(ctlr, SPI_OPMENU_LOWER, ctlr->opmenu);
>> -       ich_writel(ctlr, SPI_OPMENU_UPPER, ctlr->opmenu + sizeof(u32));
>> +       ich_spi_config_opcode(bus);
>>         return 0;
>>   }
>>
>
> Reviewed-by: Stefan Roese <sr at denx.de>

applied to u-boot-x86, thanks!