[U-Boot] [PATCH 7/9] arm64: zynqmp: Setup modeboot variable based on bootmode

[Michal Simek]

Setup bootmode variable based on bootmode selection.
This is helping with setting up boot method.
Also setup sdbootdevice.

Signed-off-by: Michal Simek <michal.simek at xilinx.com>
---

 board/xilinx/zynqmp/zynqmp.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/board/xilinx/zynqmp/zynqmp.c b/board/xilinx/zynqmp/zynqmp.c
index 8c859ed8ff8b..7aa9628414fe 100644
--- a/board/xilinx/zynqmp/zynqmp.c
+++ b/board/xilinx/zynqmp/zynqmp.c
@@ -364,23 +364,28 @@ int board_late_init(void)
 	case USB_MODE:
 		puts("USB_MODE\n");
 		mode = "usb";
+		env_set("modeboot", "usb_dfu_spl");
 		break;
 	case JTAG_MODE:
 		puts("JTAG_MODE\n");
 		mode = "pxe dhcp";
+		env_set("modeboot", "jtagboot");
 		break;
 	case QSPI_MODE_24BIT:
 	case QSPI_MODE_32BIT:
 		mode = "qspi0";
 		puts("QSPI_MODE\n");
+		env_set("modeboot", "qspiboot");
 		break;
 	case EMMC_MODE:
 		puts("EMMC_MODE\n");
 		mode = "mmc0";
+		env_set("modeboot", "emmcboot");
 		break;
 	case SD_MODE:
 		puts("SD_MODE\n");
 		mode = "mmc0";
+		env_set("modeboot", "sdboot");
 		break;
 	case SD1_LSHFT_MODE:
 		puts("LVL_SHFT_");
@@ -389,13 +394,16 @@ int board_late_init(void)
 		puts("SD_MODE1\n");
 #if defined(CONFIG_ZYNQ_SDHCI0) && defined(CONFIG_ZYNQ_SDHCI1)
 		mode = "mmc1";
+		env_set("sdbootdev", "1");
 #else
 		mode = "mmc0";
 #endif
+		env_set("modeboot", "sdboot");
 		break;
 	case NAND_MODE:
 		puts("NAND_MODE\n");
 		mode = "nand0";
+		env_set("modeboot", "nandboot");
 		break;
 	default:
 		mode = "";
-- 
1.9.1