[U-Boot] [PATCH v3 0/4] net: phy: Add Broadcom BCM53xx switch driver

[Florian Fainelli]

Hi all,

This patch series adds support for the Broadcom BCM53xx switches, in particular
BCM53125 which is found no the Lamobo R1 board.

The driver is largely based on the DSA/b53 driver Linux driver and only
incorporates what is necessary to succesfully bring-up all ports (including the
management port) for boot over the network:

=> dhcp
dw_adjust_link: Speed: 1000, full duplex
BOOTP broadcast 1
DHCP client bound to address 192.168.0.11 (3 ms)
Using ethernet at 01c50000 device
TFTP from server 192.168.0.1; our IP address is 192.168.0.11
Filename 'sun7i-a20-lamobo-r1-kernel.bin'.
Load address: 0x42000000
Loading: #################################################################
         #################################################################
         ################################
         11.6 MiB/s
done
Bytes transferred = 2371552 (242fe0 hex)
=> 

Changes in v3:
- dropped redundant phydev->priv assignment in b53_probe(), spotted by Joe

Changes in v2:

- collected Sefan's Reviewed-by and Joe's Acked-by tags
- use max() in drivers/net/designware.c as suggested by Joe

Florian Fainelli (4):
  net: phy: Add Broadcom BCM53xx switch driver
  net: designware: Pad small packets
  net: phy: b53: Add b53_reg read/write commands
  configs: Update Lamobo_R1 with B53 switch options

 configs/Lamobo_R1_defconfig |   3 +
 drivers/net/designware.c    |   5 +
 drivers/net/phy/Kconfig     |  14 +
 drivers/net/phy/Makefile    |   1 +
 drivers/net/phy/b53.c       | 765 ++++++++++++++++++++++++++++++++++++++++++++
 drivers/net/phy/phy.c       |   3 +
 include/phy.h               |   1 +
 7 files changed, 792 insertions(+)
 create mode 100644 drivers/net/phy/b53.c

-- 
2.14.1